The influence of different ADC nonlinearities on the measurement of ADC intermodulation products is discussed. It is shown that the amplitudes of harmonics and intermodulation products can be predicted only if the low order nonlinearity of the transfer curve is dominant and if a sufficient level of input noise or dither is used. 1 INTRODUCTION The ADC nonlinearities produce persistent sine wave...

The harmonic in distribution systems becomes an important problem due to an increase in nonlinear loads. This paper presents a new approach based on a graph algorithm for optimum placement of passive harmonic filters in a multi-bus system, which suffers from harmonic current sources. The objective of this paper is to minimize the network loss, the cost of the filter and the total harmonic disto...

This paper proposed the comparison made between Multi-Carrier Pulse Width Modulation, Sinusoidal Pulse Width Modulation and Selective Harmonic Elimination Pulse Width Modulation technique for minimization of Total Harmonic Distortion in Cascaded H-Bridge Multi-Level Inverter. In Multicarrier Pulse Width Modulation method by using Alternate Position of Disposition scheme for switching pulse gene...

T O ADDRESS CONCERNS ASSOCIATED WITH ELECTRICAL POWER system harmonic distortion on ships and offshore oil rigs and platforms, marine regulating bodies have introduced strict new harmonic standards. These standards define the acceptable level of harmonic voltage distortion allowed on the vessels they certify. High-harmonic distortion levels are appearing as a result of the increased use of powe...

An intelligent method based on wavelet neural network (WNN) is presented in this study to estimate voltage harmonic distortion waveforms at a non-monitored sensitive load. Voltage harmonics are considered as the main type of waveform distortion in the power quality approach. To detect and analyze voltage harmonics, it is not economical to install power quality monitors (PQMs) at all buses. The ...

this paper describes an advantageous method for using the capacitor banks in the distribution network, optimally. the aim is to determine the count, location and capacitor values in order to minimize the annual cost resulting from energy losses and capacitor bank’s installation cost. besides, in the case of having nonlinear loads in the network, by installing capacitors in appropriate locations...

9 www.alliedjournals.com  Abstract— Power quality is a very important issue. Non-linear loads and semi-conductor devices connected to AC electric mains generate unwanted signals (harmonics) in the dynamics of current which are responsible for additional power losses in heat loss and the risk of equipment damage or malfunctioning. In the simulink model of shunt active filter fuzzy logic control...

This paper describes a new strategy for pulsewidth modulation (PWM) optimized by a direct method and the application of genetic algorithms (GA) to minimize the harmonic content specifically the fifth and seventh harmonic of the total content, based on the minimum total harmonic distortion (THD). Described the development of the method, the guidelines to take into account including the algorithm...

In this paper, two algorithms have been developed for allocation and size determination of Active Power Filters (APF) in power systems. In the first algorithm, the objective is to minimize harmonic voltage distortion. The objective in the second algorithm is to minimize the new APF injection currents while satisfying harmonic standards. Genetic algorithm is proposed for these two optimization p...

In this paper, two algorithms have been developed for allocation and size determination of Active Power Filters (APF) in power systems. In the first algorithm, the objective is to minimize harmonic voltage distortion. The objective in the second algorithm is to minimize the new APF injection currents while satisfying harmonic standards. Genetic algorithm is proposed for these two optimization p...