This study aims at presenting a numerical model for predicting grout flow and penetration length into the jointed rock mass using Universal Distinct Element Code (UDEC). The numerical model is validated using practical data and analytical method for grouting process. Input data for the modeling, including geomechanical parameters along with grout properties, were obtained from a case study. The...

Abstract This paper designed a special-shaped cross-section hollow self-drilling bolt with discharge grooves, in which Mindlin’s solution of displacement was used the elastic wholly grouted bolt. Theoretically, ultimate pulling force and residual were analyzed by considering average distribution assumption stress. The bolts’ performance 2, 3, 4 grooves compared circular bolts, experimental resu...

This article develops an enhanced UHPC-grout shear connection for steel-concrete composite bridges with precast decks. The primary improvement is the use of ultra-high performance concrete (UHPC) as grout. To validate constructability and mechanical new connection, two series experimental tests (including grouting push-out tests) were conducted. Results from show that both pressure method self-...

In this preliminary study, the complexity of the corrosion phenomenon of post-tensioning strands in grouted anchorage assemblies was examined and both physicochemical and electrochemical key technical issues were identified. Measurements of oxygen reduction efficiency in high pH electrolytes were conducted to obtain polarization parameters to be used in modeling. The time evolution of electrica...

One of the main issues involved during tunnel construction with tunnel boring machines is the tail gap grouting. This gap is between the external diameter of tunnel lining and the excavation boundary that is filled with high-pressure grouting materials. In this work, three different approaches of gap grouting modeling in the FLAC3D software are investigated with a special attention to the...

Grouted post-tensioned (PTd) concrete systems are widely used in long-span segmental bridges with a target service life of 100+ years. However, the usage inadequate grout materials and grouting practices have resulted formation unwanted air voids duct, which turn led to premature corrosion (say, within about 20 years) strands failure tendons. Also, re-grouting/repairing void regions localized a...

The feasibility and sensitivity of electrochemical noise (EN), electrochemical impedance spectroscopy (EIS), and linear polarization resistance (LPR) for detection of corrosion in post-tensioning (PT) components was investigated. The use of the electrical resistance (ER) technique, as well EIS and LPR, to detect air space corrosion at the grout voids was also explored. The results showed that h...

13 The use of externally bonded steel reinforced polymer (SRP) and steel reinforced grout (SRG) is a promising new technology for increasing fl a d b a 14 15 16 17 18 19 © 20

The use of externally bonded Steel-Reinforced Polymer (SRP) and Steel Reinforced Grout (SRG) composites is a promising new technology for increasing the flexural and shear capacities of reinforced concrete (RC) members. The reinforcement system in these composites is a sheet made up of unidirectional cords consisting of tightly wound ultra high strength steel wires. The reinforcement can be mol...