Background. China is the largest producer of rape oilseed in the world; however, the mechanization level of rape harvest is relatively low, because rape materials easily adhere to the cleaning screens of combine harvesters, resulting in significant cleaning losses. Previous studies have shown that bionic nonsmooth surface cleaning screens restrain the adhesion of rape materials, but the underly...

Cylindrical telescopic crowns belong to bolt dentures, because their adhesion strength is based on the friction force. The magnitude of static and slide friction forces depends on the strain within the contact area and properties of materials employed. Friction force value between telescope elements declines in the first phase of wearing period and, subsequently, maintains particular constant v...

The development of materials for tribological applications requires test methods for the determination of friction and wear behaviour of these materials. One of many different test methods useful for this task is the "oscillating sliding test", working with a ball-on-disk configuration. This test is applicable on rather small specimens and can provide preliminary information on friction and wea...

Natural contacting surfaces have remarkable surface mechanical properties, which has led to the development of bioinspired surface structures using rubbery materials with strongly enhanced adhesion and static friction. However, sliding friction of structured rubbery surfaces is almost always significantly lower than that of a flat control, often due to significant loss of contact. Here we show ...

Using friction force microscopy, we compared the nanoscale frictional characteristics of atomically thin sheets of graphene, molybdenum disulfide (MoS2), niobium diselenide, and hexagonal boron nitride exfoliated onto a weakly adherent substrate (silicon oxide) to those of their bulk counterparts. Measurements down to single atomic sheets revealed that friction monotonically increased as the nu...

The microstructure and residual stresses of an AA6040 Al to AZ31B Mg friction stir weld are studied using scanning electron microscopy and X-ray diffraction. The complex material flow promoted by the friction stir welding process results in a fine grained structure in the stir zone of both materials due to dynamic/recovery recrystallization. The interface between the materials is characterized ...

Current address – Department of Industrial Engineering, University of Wisconsin-Milwaukee, Milwaukee, WI 53201 † Corresponding author – [email protected] Tel: (414) 229-3377 ABSTRACT Surface texture influences friction during sliding contact conditions. In the present investigation, the effect of surface texture of soft materials on friction during sliding against hard materials was studied usin...

Graphite is commonly used in brake pads. The use of graphite powder has the main goal of solid state lubrication and friction coefficient stabilization. In this article results on resin bonded brake pads with focus on noise performance and heat dissipation are presented. Experimental tests are based on model friction materials with a known formulation and a reduced number of components for a be...

T h e frict,ion behavior of rubber materials on various contact surfaces is strongly affected by the contact pressure and the relative sliding velocity. Based on a great number of experiment,^ of rubber block moving on concrete surfaces. a friction law is present,ed in this paper. It is characterized b~ a dependence on contact pressure and sliding velocity. The identification of the required pa...

We present results from an independent analysis of friction that more generally addresses all crystalline materials by an extension of coincident site lattice theory and dislocation drag. Calculations for graphitic friction are carried out and agree in magnitude with experimental friction forces. More interestingly, static, dynamic and anisotropic friction forces, incommensurability effects and...