Surface reproduction was evaluated for epoxy resin and polyether resin dies as well as for gypsum dies by observing the changes in roughness. Significant differences were found by the interaction of the impression and the dies. The resin dies generally showed better results than the gypsum dies when the elastomeric impressions were used. Especially the resin dies were both excellent in surface ...

In the annals of history the evolution of the synthetic rubber industry can be traced to the early 1930s where the first emulsion polymerised styrene butadiene rubber known as Buna S was prepared by I. G. Farbenindustrie in Germany. But it was not until the US Government in 1940 established the Rubber Reserve Company, a stockpile of natural rubber and the development of a synthetic rubber progr...

We report a general approach to fabricate elastomeric composites possessing high electrical conductivity for applications ranging from wireless charging interfaces to stretchable electronics. By using arbitrary nine kinds of rubbers as matrices, we experimentally demonstrate that the matching the solubility parameter of CNTs and the rubber matrix is important to achieve higher electrical conduc...

It is proposed to use elastomeric composites as artificial joint bearing surfaces to increase their fluid film lubrication and therefore reduce the number of failures which have been attributed to wear mechanisms. The fluid generated between the surfaces supports part of the load and prevents direct contact of the bearing surfaces. In order to obtain optimum elastohydrodynamic lubrication, elas...

This study compares the performance of two smart isolation systems that utilize superelastic shape memory alloys (SMAs) for seismic protection of bridges using energy balance concepts. The first isolation system is a SMA/rubber-based isolation system (SRB-IS) and consists of a laminated rubber bearing that decouples the superstructure from the bridge piers and a SMA device that provides additio...

A resistance-in-series model is used to describe the pervaporation performance of elastomeric membranes in the removal of volatile organic components from water. Equations have been derived to describe the organic component flux as a function of feed concentration, permeability of the organic component in the membrane, membrane thickness and liquid boundary layer mass transfer coefficient. The ...

When an elastomeric material is deformed and subjected to temperatures above some chemorheological value Tcr (near 100-C for natural rubber), its macromolecular structure undergoes time and temperature dependent chemical changes. The process continues until the temperature decreases below Tcr. Compared to the virgin material, the new material system has modified properties (often a reduced stif...

Consecutive extraction of latex and natural rubber from the roots of rubber-bearing plants such as Taraxacum kok-saghyz (TKS), Scorzonera tau-saghyz (STS), and Scorzonera Uzbekistanica (SU) were carried out. Latex extraction was carried via two methods: Blender method and Flow method. The results of latex extraction were compared. Cultivated rubber-bearing plants contained slightly higher latex...

Base isolators and fluid viscous dampers are viable protective devices that have been commonly considered in the seismic protection of civil engineering structures. However, optimal design these remains a tedious iterative undertaking due to uncertainty ground motions, nonlinear behavior structure, its change dynamic characteristics (i.e., effective stiffness damping ratio) under each new desig...

Conductive silicone rubber has great advantages for tactile sensing applications. The electrical behavior of the elastomeric material is rate-dependent and exhibit hysteresis upon cyclic loading. Several constitutive models were developed for mechanical simulation of this material upon loading and unloading. One of the successful approaches to model the time-dependent behavior of elastomers is ...