A method is described for making natural sounding modifications of the dynamic level of tones produced by acoustic instruments. Each tone is first analyzed in the frequency domain and divided into a harmonic and a noise component. The two components are modified separately using filters based on spectral envelopes extracted from recordings of isolated tones played at different dynamic levels. W...

the performance of dual-layer multiple tuned mass dampers (dl-mtmd) with uniformly distributed natural frequencies is investigated. the dl-mtmd consists of one large tuned mass damper (l-tmd) and an arbitrary number of small tuned mass dampers (s-tmd). the primary structure is represented as a single degree-of-freedom system which corresponds to a specific vibration mode to be controlled in a r...

in this paper, computer simulation of a three-phase synchronous motor drive is described. this drive/system is supplied with a new type of pulse-width modulated voltage source inverter (pwm vsi) whose amplitude of the first harmonic, compared to a conventional sinusoidal pwm vsi, is increased by about 17% and whose amplitude of higher harmonics is also reduced inversely proportional to their or...

In this paper, a dynamical system, which consists of two linear mechanical oscillators, coupled with a nonlinear damping device is considered. First, the dynamic equations are derived, then, an analytical method such as harmonic balance method, is applied to obtain the response to a harmonic base excitation. The response of the system depends on the excitation characteristics. A parametric stud...

The forced vibration behaviors are examined for nonlocal strain gradient nanobeams with surface effects subjected to a moving harmonic load travelling with a constant velocity in terms of three beam models namely, the Euler-Bernoulli, Timoshenko and modified Timoshenko beam models. The modification for nonlocal strain gradient Timoshenko nanobeams is exerted to the constitutive equations by exc...

This study targets the behavior of shear buildings equipped with tuned liquid column dampers (TLCD) which attenuate dynamic load-induced vibrations. TLCDs are a passive damping system used in tall buildings. This kind of damper has proven to be very efficient, being an excellent alternative to mass dampers. A dynamic analysis of the structure-damper system was made using the software DynaPy, de...

Processing map for hot working of Ti-IF steel has been developed in the temperature range of 750 to 1100 °C and strain rate of 0.01 to 100 s-1. This map in the austenite region exhibits a single domain with a peak efficiency of 45% occurring at 1025 °C and strain rate of 0.02 s-1. The domain extends over the temperature range of 1000 to 1100 °C and strain rate range of 0.01 to 1 s-1. The true s...