The effect of cumulative damage on the strength requirements of degrading structures is assessed through the evaluation of the target ductility and corresponding strength reduction factors of simple degrading structures. While the reduction on ductility is established through the use of Park and Ang index, the suggestions given by Bojórquez and Rivera are used to model the degradation of the st...

Ambient and cryogenic surface mechanical attrition treatments (SMAT) are applied to bcc iron plate. Both processes result in significant surface grain refinement down to the ultrafine-grained regime; the cryogenic treatment results in a 45% greater grain size reduction. However, the refined region is shallower in the cryogenic SMAT process. The tensile ductility of the grain size gradient remai...

The TWIP steels show high strain hardening rates with high ductility which results in high ultimate tensile strength. This makes their processing by equal channel angular pressing very difficult. Up to now, this has only been achieved at warm temperatures (above 200 C). In this paper, a FeMnCAl TWIP steel has been processed at room temperature and the resulted microstructure and mechanical prop...

Current concrete technology has made higher concrete grades more affordable to mid and high-rise buildings; hence its use has been increasing in the late years as it allows for smaller cross-sections, reduction of the structure’s weight, improve durability, among other benefits. However, it is known that brittleness of plain concrete increases with the strength; therefore, some national codes h...

According to standards, the durability performance of fiber-cement sheets must be evaluated by comparing the modulus of rupture (MOR) before and after durability tests (freeze-thaw, soak-dry, and warm water) are completed. This paper investigated the MOR of two different fiber-cement sheets samples before and after durability tests as well as its ductility and toughness. Results showed no signi...

in this study, for evaluating ductility of ordinary concentrically braced frames (ocbfs) and special concentrically braced frames (scbfs) which are x- braced in two adjacent middle spans, 16 steel ordinary concentrically braced frames and 16 special concentrically braced frames are studied. the results confirm that, although most of ordinary concentrically braced frames, which are x-braced, can...

Aluminum Matrix composites (AMCs) are light weight, high-strength materials with potential application in areas such as automobile, aerospace, defence, engineering and other industries. AMCs are projected to significantly reduce the overall weight of the vehicles and aircraft while maintaining satisfactory structural strength. Reinforcement of micron or nano-sized range particles with aluminium...

Knowledge of the yield point and ductility of a structure is important in seismic design. The yield point of an assembly is defined as a point where it begins to plastically deform, while ductility describes its ability to yield without substantial reduction in strength. These parameters can be determined from the analysis of the load-deformation curves resulting from destructive tests. To date...