in the present study, the mechanical behavior of aa5052 aluminum alloy during cold deformation and subsequent isothermal annealing in a temperature range of 225-300oc was investigated using the uniaxial tensile test data. it is found that by increasing the annealing time and temperature the material yield strength is decreased. the microstructural investigations of the annealed samples show tha...

Presents article is deal with optimization of the fixture for end milling process, the most important objective being the minimization of work piece deformation by changing the layout of fixture elements and the clamping forces. The main objective of this work has been the optimization of the fixtures Work piece deformation subjected to clamping forces for End milling operation. The present ana...

Abstract The present work investigates the resistance of a progressively cold-drawn carbon steel wire against hydrogen embrittlement. In this study, analytical and numerical methods are used to determine critical content, ratio embrittlement indices different material conditions. with highest degree cold deformation shows content improved At higher degrees deformation, stronger trapping, which ...

Terms of service of the steels with retained austenite in the microstructure, is severely depended on the stability of austenite during the course of deformation. The present work aims to evaluate the mechanical stability of austenite in nanostructured, carbide free bainitic steels during tensile testing and cold rolling process. To achieve the microstructure with retained austenite, the steel ...

Shot-peened nickel-base superalloys exhibit 1–2% increase in apparent eddy current conductivity (AECC), which can be exploited for nondestructive residual stress assessment. Experimental evidence indicates that the excess AECC is due in part to elastic strains, i.e., residual stress, and in part to plastic strains, i.e., cold work. The very fact that the conductivity increases rather than decre...

Deep cold rolling (DCR) and low plasticity burnishing (LPB) process are cold working processes, which easily produce a smooth and work-hardened surface by plastic deformation of surface irregularities. The present study focuses on the surface roughness and surface hardness aspects of AISI 4140 work material, using fractional factorial design of experiments. The assessment of the surface integri...

In the present study, the mechanical behavior of AA5052 aluminum alloy during cold deformation and subsequent isothermal annealing in a temperature range of 225-300oC was investigated using the uniaxial tensile test data. It is found that by increasing the annealing time and temperature the material yield strength is decreased. The microstructural investigations of the annealed samples show tha...

Cold gas dynamic spray is a coating process for fabrication of materials that are sensitive to heat and oxidation such as copper [1]. In cold spray, the particles are accelerated to supersonic velocities typically between 500 1200 m/s [1]. Upon high speed impact, the cold sprayed particles undergo extensive plastic deformation at very high strain-rates (up to 10 9 s -1 near impact interfaces), ...

Cold-rolled sheet metal that is often used in laser forming exhibits anisotropic properties, which are mostly caused by preferred orientations of grains developed during the severe plastic deformation such as cold rolling. In the present study, the textures of cold-rolled mild steel sheets are characterized and the influence of the plastic anisotropy on laser forming process is investigated. De...

 One of the surface defects that arise in sheet metal working is when the part removes from the die. Since there are no external forces to make this defect, the origin of such fail is known as residual stress. Residual stress can develop in sheet metal forming due to non uniform deformation. In this paper, the workpiece is carbon steel with different volume fractions and arrangement of ferrite ...