this paper investigates axial compression process of multi-layered tubes with circular cross-section under the axial loading in the quasi-static condition using experimental method. some specimens are prepared in seven different groups, namely; empty carbon/epoxy composite tubes, solid carbon/epoxy composite rods, empty copper tubes, composite tubes with silicon sealant filler, concentrically s...

Recently, there have been a lot of earthquakes in Japan. It is necessary to promote seismic isolation devices for buildings. The devices have been hardly diffused in attached houses, because the devices are very expensive. We should develop a low-cost seismic isolation device for detached houses. We suggested a new seismic isolation device which uses a two-layer circular tube as a unit. If hyst...

In this paper, the laser bending process of a circular tube made of mild steel has been investigated experimentally. For this purpose, the effects of the irradiating length and the number of irradiating passes on the main bending angle of a laser bent tube are studied. In addition, the main defects of the laser tube bending process such as lateral bending angle, ovality and thickness variation ...

Assessing the behavior of composite structures which are subjected to impact loads is one of the important subjects in the field of mechanical sciences. Using thin-walled tubes which collapsed and absorbed the impact energy is a well-known method to prevent damages to the other parts of the structures. In this paper, deformations, crushing length, peak load, mean force and energy absorption cap...

A modified hybrid waveguide with a wide-range coupling and long propagation has been proposed and the coupled mode theory has been applied to study the hybrid waveguide systematically. Two structures are comparatively discussed, namely, a dielectric wire and a circular capillary tube, which are buried in a polymer matrix and separated from the silver substrate by a gap. The simulated results in...

The manufacturing of the non-circular pipes made by reshaping process is becoming more and more important because of their utilizations as in different industries. In this work, a reshaping process is presented with cold rolling of a circular thick tube into a square cross section between four flat rolls in different passes. The influence of the amount of roll gap reduction in each pass on the ...

the present work is an experimental study of steady state convective heat transfer of de-ionized water with a (0.04% by volume) volume fraction of al2o3 nanoparticles dispersed to form a nanofluid that flows through an aluminium tube.laminar fully developed flow heat transfer coefficient of al2o3 nanoparticles are dispersed in water in circular tube is discussed in this paper. in order to valid...