A hybrid C+L band erbium-doped fiber amplifier/Raman fiber amplifier (EDFA/RFA) is constructed by sharing common 1480 nm pump source(s). It is based on three-level amplification mechanism in the C band and Raman shift amplification mechanism the in L band, respectively. The gain spectra of C+L band are flattened by optimally dividing the pump power ratio of 1:29 for EDFA/RFA. Gain variation is ...

An experimental investigation of high-temperature dc SQUID amplifier connected in series with a high-Tc superconductor (HTS) thin-film band-pass filter is presented. The SQUID amplifiers are designed with microstrip input coils and fabricated on bicrystal substrates of zirconia and sapphire with different misorientation angles of 24 and 37 . SQUID parameters are optimized to attain 50-X input i...

an active antenna for transmitter application in s frequency band is designed and analyzed using harmonic balance technique which is based on the nonlinear model of active devices. in this active antenna, the amplifier is integrated with the radiator which is a rectangular patch antenna. this patch antenna is analyzed employing full-wave momentum method. by applying nonlinear model of transisto...

The existing UHF Satellite Communications (SATCOM) transponders used for military applications use efficient, saturated power amplifiers, which provide one earth-coverage antenna beam. The amplifier is dedicated to small frequency band and only handles a few carriers simultaneously. The communications capacity needed to support future military forces on the move will require satellite payload p...

In this paper, we have developed a high power solid-state power amplifier (SSPA) for Sband military radars. The SSPA consists of a high power amplifier (HPA) module combined GaN based power amplifier pallets, a drive amplifier (DA) module, a digital control module and a power supply unit. The SSPA shows the total output power of 62 dBm in S-band.

A statistically based modeling technique is developed for characterizing in-band and out-of-band intermodulation and cross-modulation distortions in multichannel amplifier environments. The model is based on a new multiple envelope memoryless behavioral model that captures the black-box characteristics of multichannel amplifiers. A power amplifier with a two code-division multiple-access channe...

A novel technique for a self-equalized distributed amplifier is presented by showing the analogy between transversal filters and distributed amplifier topologies. The appropriate delay and gain coefficients of amplifier circuit are obtained by a Fourier expansion of the raised cosine spectrum in the frequency range of 0-40GHz.

This study entailed the development of a K-Band power amplifier (PA). The proposed PA was implemented and verified using 65-nm bulk CMOS process. designed with two stages to obtain sufficient gain in K band. had chip area 0.93×0.47 mm2 including RF DC pads. manufactured design maximum saturation 22.4∼22.7 dBm 19–21 GHz frequency band, added efficiency (PAE) 39 %∼40 %. In two-tone simulation res...

Optical communication systems, operating in C-band, are reaching their theoretically achievable capacity limits. An attractive and economically viable solution to satisfy the future data rate demands is employ transmission across full low-loss spectrum encompassing O, E, S, C L band of single mode fibers (SMF). Utilizing all five bands offers a bandwidth up $\sim$53.5THz (365nm) with loss below...