Carefully designed indentation creep experiments and detailed finite-element computations were carried out in order to establish a robust and systematic method to extract creep properties accurately during indentation creep tests. Samples made from an Al–5.3mol%Mg solid-solution alloy were tested at temperatures ranging from 573 to 773K. Finite-element simulations confirmed that, for a power-la...

Despite decades of intensive research, an entirely satisfactory constitutive relation for creep in concrete is still unavailable, even for working stress levels [I]. The rate-type creep laws with internal variables [2], although rather effective for numerical creep analysis of large structural systems, seem to be incapable of describing the aging phenomena without at least partially violating s...

The spatial fluctuations of deformation are studied in the creep in Andrade's power law and the logarithmic phases, using paper samples. Measurements by the digital image correlation technique show that the relative strength of the strain rate fluctuations increases with time, in both creep regimes. In the Andrade creep phase characterized by a power-law decay of the strain rate ϵt∼t(-θ), with ...

The recurrence intervals of repeating earthquakes on the San Andreas Fault in the Loma Prieta aftershock zone follow the characteristic 1/t decay of Omori’s law. A model in which these earthquakes occur on isolated patches of the fault that fail in stick-slip with creep around them can explain this observation. In this model the recurrence interval is inversely proportional to the loading rate ...

This paper reports (1) the latest development and application of a modified hyperbolic sine law for minimum creep strain rate and stress for both low Cr and high Cr steels, and (2) the development of a creep fracture criterion based on cavity area fraction along grain boundaries for high Cr steel. This work is part of the fundamental development of creep damage constitutive equations which were...

The equivalent circuit concept derives from the Superposition Principle and Ohm’s Law. Two forms of the equivalent circuit, the Thévenin equivalent and the Norton equivalent, distill any linear circuit into a source and an impedance. The development of these equivalents spans almost seventyfive years, with others than the eponymous people assuming equally important roles. This report describes ...

In this article, the problem of time-dependent stress redistribution of a piezomagnetic rotating thick-walled cylinder under an axisymmetric hygro-thermo-magneto-electro-mechanical loading is analyzed analytically for the condition of plane strain. Using the constitutive equations, a differential equation is found in which there are creep strains. Primarily, eliminating creep strains, an analyt...

The scale dependence of the strength of virtually homogeneous rock is usually considered to be insignificant but the spectrum of discontinuities plays a very important role for the strength of differently sized rock elements and also controls the rock creep strain. Large-scale load tests comprised recording of the creep strain rate that was found to be strongly retarded and negligible for stres...

Time-dependent creep analysis is presented for the calculation of stresses and displacements of axisymmetric thick-walled cylindrical pressure vessels made of functionally graded material (FGM). For the purpose of time-dependent stress analysis in an FGM pressure vessel, material creep behavior and the solutions of the stresses at a time equal to zero (i.e. the initial stress state) are needed....

[1] We developed a robust Bayesian inversion scheme to plan and analyze laboratory creep compaction experiments. We chose a simple creep law that features the main parameters of interest when trying to identify rate-controlling mechanisms from experimental data. By integrating the chosen creep law or an approximation thereof, one can use all the data, either simultaneously or in overlapping sub...