Microstructural evolutions during annealing of cold rolled AISI 304L and AISI 316L stainless steels were studied. Cold rolled AISI 304L alloy was fully martensitic but cold rolled AISI 316L alloy was partially martensitic due to the higher stability of the austenite phase in the latter. During continuous heating to elevated temperatures, the complete reversion of strain-induced martensite at 75...

Reaction zones formed at 790 °C between solid titanium and liquid Ag-Cu eutectic alloys (pure and Ti-saturated) have been characterized. When pure Ag-Cu eutectic alloy with 40 at.% Cu is used, the interface reaction layer sequence is: αTi / Ti2Cu / TiCu / Ti3Cu4 / TiCu4 / L. Because of the fast dissolution rate of Ti in the alloy, the reaction zone remains very thin (3-6 μm) whatever the reacti...

Cast stainless steel CF8C-Plus (19wt%Cr/12%Ni) has excellent creep properties, but limited oxidation resistance above 700°C in environments containing H2O. One strategy to improve the alloy oxidation performance is to increase the Cr and Ni concentration. Two new alloys, with, respectively, 21wt%Cr–15wt%Ni and 22wt%Cr–17.5wt%Ni were therefore developed and their long-term oxidation behaviors in...

3 Ordered Cu-(35–50) at.% Pd alloys (B2-type superstructure) have a high corrosion resistance and are distinguished by possessing very low electrical resistivity r » (4–8) × 10 ohm m (1), two properties which make them of interest to researchers developing functional materials. However, wide-scale use of these alloys is hindered by their relatively poor strength properties: the yield stress of ...

Upon the isothermal oxidation of an ODS FeAl Grade 3 intermetallic alloy, a structured oxide scale is developed between 800 and 950o C. TEM studies have revealed a three-layered structure with a top nanoequiaxed alumina, a central alumina and a bottom Fe-Al spinel. At these temperatures, aluminium outward diffusion does not seem to be suppressed neither by the spinel sub-layer nor by the yttria...

This study assessed whether there are differences in marginal fit between laser-fusion and conventional techniques to produce fixed dental prostheses (FDPs). A master steel die with 2 abutments was produced to receive a posterior 4-unit FDPs and single copings. These experimental models were divided into three groups (n = 20/group) manufactured: group 1, Ni-Cr alloy, with a lost-wax casting tec...

An Ag-Pd-Cu-Au casting alloy was subjected to solution treatment at various temperatures. The dynamic hardness of each resultant microstructure and the Vickers hardness of the whole alloy were measured to investigate their relationship with changes in metal and crystal structure of the alloy and microstructural elemental concentration. The samples following solution treatment at 650, 700, 750, ...