Rheological properties of different heavy oils and their emulsions were measured using RheolabQC rheometer, and their phase inversion were observed using XP-300C microscopic image system. The viscosity of water in oil emulsions constantly increases as the content of bound water rises, and suddenly decreases while it increases to a certain extent, which is corresponding to its phase inversion po...

Stability of multivitamins containing drug products especially the syrups remains one most important factor which restrains from getting desired therapeutic effects as its ingredients decompose quickly compared to other Active Pharmaceutical Ingredients (APIs), therefore, stability assessment is necessary check effect climatic conditions on syrups’ decomposition. The study aimed assess level de...

Thin silicon nitride (Si3N4) films deposited using plasma-enhanced chemical deposition (PECVD) method have been used as metalinsulator-metal (MIM) capacitor dielectric for GaAs heterojunction bipolar transistor (HBT) technology. The characteristics of the films, which were deposited at 300C, were found to be dependent on how the PECVD film was deposited. A silicon nitride film deposited as a mu...

The factors necessary to obtain an optimal heat treatment that influence the hardness and resistivity of Al-6Si-0.5Mg casting alloys with Cu or/and Ni additions were investigated. The alloys were homogenised (24hr at 500C), solutionized (2hr at 540C) and artificially ageing at various times and temperatures. The alloys were aged isochronally for 60 minutes at temperatures up to 400C and isother...

Brake lining, a friction lining material has over the years been produced mainly from asbestos. Asbestos health hazards have necessitated need to source materials other safer directions. A novel composite local was developed. The brake production dispersion hardening process by techniques of powder metallurgy finely divided particles raw mix. included sawdust, resin, rubber latex, clay, carbon ...

ZnO nanorods with different sizes and shapes have been successfully synthesized via a simple hydrothermal route, using zinc acetate and Cetyltriammonium bromide (CTAB) as the reactants. The thick films of as prepared ZnO were prepared by screen-printing technique in desired pattern. The films are characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM) and transmission elect...

The present study analyses the potential of acid treated chitosan for simultaneous co-adsorptive removal of phenol and cyanide from a binary waste water solution. The effects of parameters like pH, temperature, initial concentration, adsorbent dose, and adsorbent size were studied. At an optimum pH of 8, temperature of 300C, initial phenol and cyanide concentration of 200 mg/L and 20 mg/L respe...

This paper presents the results of an experimental study of the mechanical properties of FRP reinforcement bars, used as internal reinforcement in concrete structures, at elevated temperatures. Two types of FRP bars namely: carbon fibre reinforced polyester bars of 9.5mm diameter and glass fibre reinforced polyester bars of 9.5mm and 12.7 mm diameter were used in the study. For comparison, conv...

Effect of artificial ageing temperature on the mechanical properties of Al-6Si-0.5Mg alloy containing 0.5 – 4 wt% Cu was studied. The solution treated alloys containing different amounts of Cu were aged isochronally for 1 hour at temperatures up to 300C. The precipitation stages during ageing were monitored by hardness measurements. Tensile and impact properties were determined by standard test...