This paper investigated the improvement of mechanical properties for one most used biomaterials, titanium-based alloy. To improve its properties, molybdenum was chosen to be added Ti and Ti-Zr alloys through a blending process. After homogenization (12, 15) Mo Mo-6 Zr, compaction pressure sintering temperature were varied create pellets. Characterization has been done using scanning electron mi...

Abstract With the further development of nuclear power, fuel burn-up continues to increase and refueling cycle is extended, which puts forward higher requirements for performance cladding materials. In this paper, Zr-Nb-0.1Fe-x (0.05%, 0.1%, 0.2%) Cu alloy samples were prepared by using process route parameters industrial production zirconium plates. The effects content on microstructure Zr-Nb ...

The effects of process parameters and aging treatment on the microstructure mechanical properties selective laser melting (SLM) fabricated high Mg-content Al-Mg-Sc-Zr aluminum alloy were systematically studied. Our experiment results show that samples exhibit good processability with porosity less than 1%. increase Mg content in is beneficial to reduce texture alloy. scanning speed has a large ...

Titanium and Zircaloy-4 dissimilar alloys were brazed with a zirconium-titanium-copper-nickel amorphous filler alloy, the resulting joint structures as well their corrosion properties examined. The microstructure of joints was investigated according to brazing holding time at 850 °C, property analyzed by potentiodynamic polarization. During brazing, produced diffusion-induced isothermal solidif...

Zr-based bulk metallic glass is an amorphous alloy. In order to study the burr problem in groove milling process of glass, force studied experimentally. Then effect parameters on was studied, and relationship between analyzed. further alloy, under same test parameters, single crystal alloy material (nickel base superalloy DD5) traditional polycrystalline metal (304 stainless steel) were selecte...

The objective of this research is to study the effect Zr on L-PBF processability, microstructure, and microhardness an AlZnMgCu-Zr alloy. Two AlZnMgCu-0.5 1.5 wt% pre-alloyed powders were produced by casting followed gas atomization. In addition, excess Mg Zn was added target compositions compensate for vaporization during L-PBF. as-atomized as-built heat treated specimens characterized via sca...