This paper is proposed to improve the efficiency of the series resonant inverter for industrial heating applications. Resonant inverters are those operate at high frequency with reduced losses preferable for induction heating. Resonating components and switching device which are placed in series to load forms series resonant inverter. Inverter which is characterized by full bridge made up of In...

In this article, a dual-frequency control method for regulating the output power in class-E resonant dc–dc converters has been introduced. As standard on – xmlns:xlink="http://www.w3.org/1999/xlink">off or other recently proposed controls, approach is based on ability of converter to al...

Abstract—In this paper, a high-conversion-ratio bidirectional dc–dc converter with coupled inductor is proposed. In the boost mode, two capacitors are parallel charged and series discharged by the coupled inductor. Thus, high step-up voltage gain can be achieved with an appropriate duty ratio. The voltage stress on the main switch is reduced by a passive clamp circuit. Therefore, the low resist...

Abstract: Due to the low cost, small size, and ease of control, the switched-capacitor (SC) battery equalizers are promising among active balancing methods. However, it is difficult to achieve the full cell equalization for the SC equalizers due to the inevitable voltage drops across Metal-Oxide-Semiconductor Field Effect Transistor (MOSFET) switches. Moreover, when the voltage gap among cells ...

This paper presents a current-fed full-bridge boost DC-AC-DC converter with transformer isolation operating without switching power dissipation. The output voltage is regulated by dc-ac converter whose frequency changes with a constant turn-off time of transistors. The proposed converter is devoid of parasitic oscillations, as all of the parasitic capacitances and inductances are included in a ...

In this paper, the method and a control algorithm for detecting resonant destruction of auxiliary power supply railway vehicle are proposed. It is essential to reduce weight electric equipment attached lower part because it greatly affects life vehicle, such as wheel bearing. order volume supply, in case windings, high-speed switching should be performed by lowering input voltage. Therefore, us...

VAR support should be supplied as close to the load as possible to minimize transmission losses. For voltage control and for improvement of total power factor in a distribution system the circuit- breaker switched capacitor banks can be used. The problems with this solution are the voltage steps caused by the large sizes of the capacitor banks as well as the transients caused on insertion. Thyr...

Reduced switching loss favours Pulse Skipping Modulation mode of switching dc-to-dc converters at light loads. Under certain conditions the converter operates in discontinuous conduction mode (DCM). Inductor current starts from zero in each switching cycle as the switching frequency is constant and not adequately high. A DC-to-DC buck converter is modelled and simulated in this paper under DCM....

The main objective of this paper, a bidirectional dc–dc converter with duel coupled inductor is proposed. In the boost mode, two capacitors are parallel charged and series discharged by the coupled inductor. Thus, high step-up voltage gain can be achieved with an appropriate duty ratio. The voltage stress on the main switch is reduced by a passive clamp circuit. Therefore, the low resistance RD...