In this work, a study of the wear transition regimes was carried out for a pin-on-disk sliding couple, involving two steels of different hardness and Cr contents. Dry sliding wear behaviour of the more highly alloyed stainless steel was dominated by adhesive wear and tribo-oxidation at relatively low sliding speeds and by mixed and adhesive wear at high speeds and loads. In contrast, oxidative ...

Optical components of non-planar geometry require special machining to produce. Single point diamond turning is the manufacturing method of choice to produce these surfaces. Three main factors contribute to the quality of these surfaces. Machine accuracy has shown improvements with the increased use of air bearings. Tool wear and design are shown to be effected by the crystal orientation of the...

On time replacement of a cutting tool with a new one is an important task in Flexible Manufacturing Systems (FMS). A fuzzy logic-based approach was used in the present study to predict and simulate the tool wear progress in turning operation. Cutting parameters and cutting forces were considered as the input and the wear rate was regarded as the output data in the fuzzy logic for construct...

The average life span of knee prosthesis used in Total Knee Replacement (TKR) is approximately 10 to 15 years. Literature indicates that the reasons for implant failures include wear, infection, instability, and stiffness. However, the majority of failures are due to wear and tear of the prosthesis. The most common biopolymer used in TKR  is Ultra High Molecular Weight Polyethylene (UHMWPE). Pr...

Abstract For studying the influencing factors of wheel set wear on high-speed trains, a large number simulation analyses have found that line conditions, speed, tread profile, adhesion coefficient, contact geometry, and other varying degrees impact wear. However, based difficulty dynamic measurement, it cannot be directly verified. By establishing rigid-flexible model for correlation between pa...

in this study, gtaw process and cored wires were used to coat al/al3ti wear resistant composite on a commercial pure al substrate. wire drawing process was utilized to produce the cored wires from aluminum strips and a mixture of titanium and aluminum powders. the microstructures and the present phases were investigated by metallographic, sem equipped with eds and xrd analysis. moreover, the ha...

the plain carbon steel “ck45” has relatively well mechanical and metallurgical properties and low cost. the purpose of this research was the property evaluation of this steel on abrasive wear and impact for using in plows and other tillage tools. tillage tool should resist in abrasive wear and impact simultaneously. several heat treatments were done on specimens of this steel. a standard test d...