An integral analysis of hydrodynamics and heat transfer in a thin liquid film flowing over a rotating disk surface is presented for both constant temperature and constant heat flux boundary conditions. The model is found to capture the correct trends of the liquid film thickness variation over the disk surface and compare reasonably well with experimental results over the range of Reynolds and ...

The paper discusses an application of the Computational Fluid Dynamics (CFD) method to support the development and validation of a computationally-affordable method named Effective Convectivity Model (ECM) for simulation of turbulent natural convection heat transfer and phase changes in a decay-heated corium pool in the Boiling Water Reactor (BWR) lower head. The CFD method simulations enable d...

To investigate the mechanisms leading to the heat deposition onto the first wall in the Scrape-Off Layer (SOL), we perform dedicated numerical non-linear simulations of the SOL plasma dynamics of a TCV discharge using the GBS code. The simulated parallel heat flux profiles on the limiter agree qualitatively with the experimental ones obtained by means of infrared thermography, showing a double ...

In the present study, numerical study of Al2O3-water nanofluid flow in different coiled wire inserted tubes are performed to investigate the effects of inserting coiled wires in tubes on the fluid dynamic and heat transfer performance ofv nanofluids. The numerical simulations of nanofluids are performed using two phase mixture model. The flow regime and the wall boundary conditions are assumed ...

Ultrasonic time of flight measurements have been used to estimate the interior temperature of propulsion systems remotely. All that is needed is acoustic access to the boundary in question and a suitable model for the heat transfer along the path of the pulse train. The interior temperature is then deduced from a change in the time of flight and the temperature dependent velocity factor, which ...

Using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. Use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. In this work two-dimensional incompressible laminar flow of a nanofluid e...

Flashover is a phenomenon describing a room fire changed from the growth stage to the development stage. There is a rapid increase in size and intensity. The radiant heat flux back to the fuel surface and the floor of the room is known to be one of the key parameters leading to flashover. Indeed, a heat flux (largely due to radiation) of 20 kW/m to the room floor is often taken to be the condit...

The present article focuses on the evaluation of a first-moment closure model applicable to film cooling flow and heat transfer computations. The present first-moment closure model consists of a higher level of turbulent heat flux modeling in which two additional transport equations for temperature variance kθ and its dissipation rate εθ are ...

Longitudinal heat conduction is an important parameter in the cryogenic field, especially in cryogenic heat exchangers. In the present work, the parasitic effect of tube wall longitudinal heat conduction on temperature measurement has been studied in cryogenic laminar hydrogen flow. The effects of various parameters such as wall cold end temperature, wall thermal conductivity, gas volumetric fl...

in this paper, the effects of baffle on thermal characteristics of combined convection-radiation heat transfer in laminar flow adjacent to an inclined backward facing step (bfs) in a horizontal duct are investigated. a baffle is mounted on the top wall of channel downstream side of step. in this study, the fluid is treated as a gray, absorbing, emitting and scattering medium; therefore, in the ...