This paper looks at the problem of placing Static Var Compensators to provide maximum transfer capability for all possible generation mixes. The margin to low voltage limit is one of the quantities used to determine power system transfer capability. A fast method for finding the location of SVC systems that will have the greatest impact on the low voltage margin will be shown. The IEEE 24 bus s...

Methods for calculating Available Transfer Capability (ATC) of the transmission systems may be grouped under Static and Dynamic methods. This paper presents a fast dynamic method for ATC calculations, which considers both Transient Stability Limits and Voltage Stability Limits as terminating criteria. A variation of Energy Function Method is used to determine the transient stability limit and t...

Inverter voltage control is an important task in the operation of a DC/AC microgrid system. To improve the inverter voltage control dynamics, traditional approaches attempt to measure and feedforward the load current, which, however, needs remote measurement with communications in a microgrid system with distributed loads. In this paper, a load current observer (LCO) based control strategy, whi...

Reliable operation of large scale electric power networks requires that system voltages and currents stay within design limits. Operation beyond those limits can lead to equipment failures and blackouts. Security margins measure the amount by which system loads or power transfers can change before a security violation, such as an overloaded transmission line, is encountered. This thesis shows h...

The buck converter is one of DC/DC converters that are often used as power supplies. This paper presents parameter tuning methods to obtain circuit element values for the buck converter to minimize the output voltage variation under load changing environments. The conventional method using the concept of the phase margin is extended to have optimal phase margin that gives slightly improved perf...

Integration of Distributed Generation (DG) in an electrical distribution system has increased recently due to voltage improvement, line loss reduction, environmental advantages, and postponement of system upgrading, and increasing reliability. Improper location and capacity of DG may affect the voltage stability on the Distribution System (DS). Optimization techniques are tools used to predict ...

Methods for calculating Available Transfer Capability (ATC) of the transmission systems may be grouped under Static and Dynamic methods. This paper presents a fast dynamic method for ATC calculations, which considers both Transient Stability Limits and Voltage Stability Limits as terminating criteria. A variation of Energy Function Method is used to determine the transient stability limit and t...

In this work, the off-state characteristics of AlScN/GaN high electron mobility transistors (HEMTs) grown by metalorganic chemical vapor deposition (MOCVD) were studied and directly compared to an AlGaN- AlN-HEMT in same MOCVD. Pinch-off instability leaky capacitive measurements observed for AlScN-based HEMTs, which was correlated with a higher ideality factor lower effective potential barrier ...

An accelerated evaluation method for the SRAM cell write margin is proposed using the conventional Write Noise Margin (WNM) definition based on the “butterfly curve”. The WNM is measured under a lower word line voltage than the power supply voltage VDD. A lower word line voltage is chosen in order to make the access transistor operate in the saturation mode over a wide range of threshold voltag...