A novel zero-voltage-switching (ZVS) phase-shift isolated bidirectional DC-DC converter is proposed. It is composed of two symmetrical active-clamped circuits, one on each side of an isolation transformer. The converter can achieve full ZVS in both forward and backward modes even under noload condition. The converter also has a fast response. The operation principle and low-frequency model of t...

A novel soft-switching two-switch flyback converter is proposed in this paper. This converter is composed of two active power switches, a flyback transformer, a blocking diode, and two passive regenerative clamping circuits. The proposed converter has the advantages of a low cost circuit configuration, a simple control scheme, a high efficiency, and a wide operating range. The circuit topology,...

This study presents a two-switch continuous conduction mode pulse width modulation flyback converter that employs an LC snubber circuit. The snubber circuit is used to achieve zero voltage switching (ZVS) operation for the main switches during the turn-off transition and soft switching for power diodes. With the proposed LC snubber, the magnetic energy in the transformer leakage inductance can ...

A novel soft switching PWM converter for high frequency ACIDC andlor DCIAC power conversion is presented by using a new parallel resonant dc-link(PRDCL) and by adopting single phase soft switching(SPSS) technique. The new PRDCL provides variable link pulse position as well as variable link pulse ,width. which is quite different feature from the other resonant dc-links and thus the PWM capabilit...

In this project presents a new non conventional energy source based bidirectional dc/dc converter for transfer the power in both directions. The nonconventional source of solar energy with Maximum Power Point Tracking is used to avoid the demand of electric power, which is inexhaustible and non pollution .The maximum power point traction is the combination of switch mode converter and Controlle...

The DS1875 features a pulse-width modulation (PWM) controller that can be used to control a DC-DC converter. The DC-DC converter can then be used to generate the high bias voltages necessary for avalanche photodiodes (APDs). This application note describes the operation of a boost converter that uses the DS1875. Discussion covers the selection of the inductor and switching frequency, and the se...

Design-oriented analysis of switching converters must take into account how disturbances and variations in the input and control signals affect the optimum performance of these converters. Sate-space averaging of a nonideal boost converter is presented in this paper. DC state and small signal AC state modeling of the converter was derived. Determination of line-to-output transfer function, whic...

Digital control techniques for Boost Converter and PWM Inverter which have potential application for power transmission system. The study is done in the field of inverter topologies, which is used to interface a wind energy module to the power grid/load. The boost converter and inverter are developed with focus on low cost, high reliability and massproduction. The switching strategy to control ...

A new phase-controlled resonant inverter is obtained by paralleling the ac loads of two identical parallel resonant inverters. A phase shift between the drive signals of the two inverters controls the amplitude of the output voltage of the new inverter. A voltage-driven rectifier is used as an ac load of the inverter which results in a phase-controlled parallel resonant dc-dc converter. A frequ...

An analysis of an on-chip buck converter is presented in this paper. A high switching frequency is the key design parameter that simultaneously permits monolithic integration and high efficiency. A model of the parasitic impedances of a buck converter is developed. With this model, a design space is determined that allows integration of active and passive devices on the same die for a target te...