Eroded enamel is more susceptible to abrasive wear than sound enamel. New toothpastes utilizing diamond particles as abrasives have been developed. The present study investigated the abrasive wear of eroded enamel by three commercially available toothpastes (one containing diamond particles) and compared it to the respective wear of sound enamel caused by these toothpastes. Seventy-two bovine e...

Chemical mechanical polishing (CMP) is a manufacturing process in which a wafer surface is polished by pressing it against a rotating pad that is flooded with slurry. The slurry itself is a fluid containing abrasive particles. Past experimentation has shown that the distribution of suspended particles in the slurry is significantly related to the distribution of material removal on the wafer du...

A laboratory scale aeration treatment system was built to study the fate of nitrogen during aeration of pig slurry. For each run evaluated, the nitrogen mass balance was determined including measurement of the nitrous oxide gas emissions. Intermittent aeration led to a nitrogen removal of about 53% of the total nitrogen content of the raw slurry. About 18% of the total nitrogen content of the r...

In the present study, the ice slurry refrigeration system with pre-cooling heat exchanger (ISSH) is studied experimentally to achieve the system performance, ice crystal formation time and the temperature of ice crystal formation. The operating parameters considered in this paper include the concentration of salt solution, suction pressure, discharge pressure and Energy Efficiency Ratio (EER). ...

To analyze the flow of an underfill encapsulant between the chip and substrate, a shear viscosity model is needed. This paper presents a model of the viscosity for the flow of slurry between two parallel walls, which is a typical situation found in electronic packaging applications. It is postulated that the flow behavior of a dense slurry is governed by the particle-particle and particle-wall ...

The direct synthesis process of dimethyl ether (DME) from syngas in slurry reactors is considered to be promising because of its advantages in caloric transfer. In this paper, the influences of operating conditions (temperature, pressure and weight hourly space velocity) on the conversion of CO, selectivity of DME and methanol were studied in a stirred autoclave over Cu-Zn-Al-Zr slurry catalyst...

BACKGROUND Environmental issues, such as the fossil energy crisis, have resulted in increased public attention to use bioethanol as an alternative renewable energy. For ethanol production, water and nutrient consumption has become increasingly important factors being considered by the bioethanol industry as reducing the consumption of these resources would decrease the overall cost of ethanol p...

This study investigates preparation of melamine formaldehyde / montmorillonite nanocomposite coatings and evaluates its abrasion resistance property as a new material for wood based panel products. The ultrasonicated MF resin/clay blends with different clay loadings were applied in the form of coatings to the saturated decorative paper to prepare thermoset prepregs. Morphology and structure of ...

In this study, the effect of slip casting parameters on the ultrafine microstructure and the density of pore-free YAG ceramic was evaluated. A stable, high concentrated aqueous YAG slurry using Dolapix-CE64 as a dispersant was prepared. The effect of dispersant concentration as well as the solid load on the stability and rheological behavior of the slurry was also studied. The optimal dispersan...

-Hardfacing is one of the most useful and economic ways to improve the performance of components submitted to severe wear conditions. A study was made to compare the microstructure and abrasion resistance of hardfacing alloys reinforced with primary chromium carbides, the hardfacing alloys were deposited onto M.S. plate by SMAW process. Two different commercial hardfacing electrodes were employ...