The ability to map plastic deformation around high strain gradient microstructural features is central in studying phenomena such as fatigue and stress corrosion cracking. A method for the visualization of plastic deformation in electron back-scattered diffraction (EBSD) data has been developed and is described in this article. This technique is based on mapping the intragrain misorientation in...

Cyclic plastic deformation introduced by forging with a rotating lower anvil leads to materials with grain size between 20 and 200 nm, depending on various factors. This severe plastic deformation process known as High Pressure Torsion (HPT) can be used for forming nanopowders in order to refine their microstructure. Mechanical properties of such products are given by the amount of plastic defo...

Metallic auxetic metamaterials are of great potential to be used in many applications because of their superior mechanical performance to elastomer-based auxetic materials. Due to the limited knowledge on this new type of materials under large plastic deformation, the implementation of such materials in practical applications remains elusive. In contrast to the elastomer-based metamaterials, me...

The mechanism responsible for deformation-induced crystalline-to-amorphous transition (CAT) in silicon is still under considerable debate, owing to the absence of direct experimental evidence. Here we have devised a novel core/shell configuration to impose confinement on the sample to circumvent early cracking during uniaxial compression of submicron-sized Si pillars. This has enabled large pla...

Hardness and plastic deformation during Vickers indentation in as-cast, annealed, and fully crystallized Zr57Cu27Al11Ni5 bulk metallic glass was examined. Subsurface deformation morphology under the indenter tip was studied at various loads and for different annealing time. Appreciable plastic deformation, through shear banding, occurs in the as-cast and annealed alloys. Two different types of ...

An investigation into the properties of granular materials is undertaken via numerical simulation. These simulations highlight that frictional contact, a defining characteristic of dry granular materials, and interfacial debonding, an expected deformation mode in plastic bonded explosives, must be properly modeled. Frictional contact and debonding algorithms have been implemented into FLIP, a p...

Constitutive laws and crystal plasticity in diamond deformation have been the subjects of substantial interest since synthetic diamond was made in 1950's. To date, however, little is known quantitatively regarding its brittle-ductile properties and yield strength at high temperatures. Here we report, for the first time, the strain-stress constitutive relations and experimental demonstration of ...

abstractin this paper, we investigate effect of fe–intermetallic compounds on plastic deformation of closed-cell composite aluminum foam as filler of thin-walled tubes. however, deformation of the aluminum foam-filled thin-walled tubes as crushed-box will be presented in part (ii). composite foams of alsi7sic3 and alsi7sic3-(fe) as closed cell were synthesized by powder metallurgy foaming metho...

The process of nanocontact including indentation and retraction between a large Ni tip and a Cu substrate is investigated using quasicontinuum (QC) method. The multiscale model reveals that significant plastic deformation occurs during the process of nanocontact between Ni tip and Cu substrate. Plastic deformation is observed in an area as large as 20 nm wide and 10 nm thick beneath Ni tip duri...

the brass tubes with foam cores of alsi7sic3, alsi7sic3fe1 and alsi7sic3fe3 were produced as the crush-boxes with circle and square cross-section. then axial compressive behavior and energy absorption capability of the foam-filled tubes were investigated during the quasi-static progressive plastic buckling. the uniaxial compressive stress–strain curves of the foam-filled brass tubes exhibited t...