In this study, numerical simulations on laminar flow in sinusoidal wavy shaped tubes were conducted for mean Reynolds number of 250, which is in the range of physiological flow-rate and investigated flow structures, pressure distribution and particle trajectories both in steady and periodic inflow conditions. For extensive comparisons, various wave lengths and amplitudes of sine function for ge...

A numerical experiment is carried out to study the suitability of two-dimensional (2D) depth-averaged modeling for bend-flow simulation, in which the geometry of the studied channel is rectangular. Two commonly used 2D depth-averaged models for bend-flow simulation are considered in this study of which the bend-flow model includes the dispersion stress terms by incorporating the assumption of s...

OBJECTIVES This case study aims to demonstrate the method's feasibility and capacity to improve quality of care. Several drawbacks attached to tracer condition and selected procedure audits oblige clinicians to rely on external evaluators. Interface flow process audit is an alternative method, which also favours integration of health care across institutions divide. METHODS An action research...

Simultaneous velocity measurements were taken using Particle Image Velocimetry (PIV) and an Acoustic Doppler Velocity Profiler (ADVP) in a sharp open-channel bend with an immobile gravel bed. The PIV measures 3D velocity vectors in a vertical plane (~40cm x 20cm) at a frequency of 7.5 Hz, whereas the ADVP measures 3D velocity vectors in a vertical profile with a frequency of 31.25 Hz. The paper...

in the construction process of a plastic concrete cut-off wall, concreting is usually performed using the termie pipe method. in this method, concreting is performed from the lowest point in the excavated trench (containing the slurry) using a funnel and the pipe connected to it. the concrete poured in the funnel gradually settles in the panel through the termie pipe which is beneath the slurry...

hydraulic simulation of water flow in irrigation canals may reveal management shortcomings and help managers find solutions to them. hydraulic simulation models can be appropriate tools for understanding hydraulic behavior of irrigation systems. in the present study, the steady state hec-ras model was tested and compared with the mike 11 unsteady state model. a secondary irrigation canal in the...

A DNS parametric study of streamwise?aligned rectangular ridges is carried out in a fully developed turbulent channel flow with constant rate at $Reb = 18000$. The simulations were systematically varying the ridge height h, width w and structural wavelength $S$. generate strong large?scale secondary motion, which measured terms integral swirl strength. Of presented cases, configuration height$ ...