In the present study, position estimation of switched reluctance motor (SRM) has been achieved on the basis of the artificial neural networks (ANNs). The ANNs can estimate the rotor position without using an extra rotor position sensor by measuring the phase flux linkages and phase currents. Flux linkage-phase current-rotor position data set and supervised backpropagation learning algorithm are...

This paper presents an improved control strategy for both the rotor side converter (RSC) and grid side converter (GSC) of a doubly fed induction generator (DFIG)-based wind turbine (WT) system to enhance the low voltage ride through (LVRT) capability. Within the proposed control strategy, the RSC control introduces transient feed-forward compensation terms to mitigate the high frequency harmoni...

VFT (variable frequency transformer) has been recently used as an alternative to HVDC (high voltage direct current) to control power flow between asynchronous networks. VFT consumes less reactive power than a back-to-back HVDC system, provides faster initial transient recovery, and has better natural damping capability. VFT is simply a DFIM (doubly-fed induction machine) where the machine torqu...

A numbers of important developments have led to an increasing attractiveness for very high speed electrical machines (either motor or generator). Specifically the increasing switching speed of power electronics, high energy magnets, high strength retaining materials, better high speed bearings and improvements in design analysis are the primary drivers in a move to higher speed. The design chal...

Broken rotor bars in induction motors can be detected by monitoring any abnormality of the spectrum amplitudes at certain frequencies in the motor current spectrum. Broken rotor bar fault detection schemes should rely on multiple signatures in order to overcome or reduce the effect of any misinterpretation of the signatures that are obscured by factors such as measurement noises and different l...

This paper develops a model reference adaptive system (MRAS) based observer for sensorless vector control of permanent magnet synchronous motor (PMSM) drives. There are used two models in MRAS observer to estimate the linkage flux with relatively clean waveforms. The voltage model in stator reference is the reference model, and the current model in estimated rotor reference is the adaptive mode...

This paper presents design, analysis and comparison of the different rotor type permanent magnet machines. The presented machines are designed as having same geometrical dimensions and same materials for comparison. The main machine parameters of interior and exterior rotor type machines including eddy current effect, torque-speed characteristics and magnetic analysis are investigated using MAX...

A nano coaxial rotor was designed, fabricated and studied experimentally at an ultralow Reynolds number ranging from 5000 to 20,000. The Minimum Induced Loss theory was employed to optimize the geometry of nano coaxial rotor with the introduction of weights to take into account the interference of upper rotor and lower rotor. The chord and twist distributions of both rotors were achieved as a r...

The development procedure of permanent magnet drives for sensor less operation beginning from standstill under overload conditions has to consider different design aspects coevally. First, the robust rotor position sensing by test signal enforces a design with a strongly different behavior of the spatial dq-oriented differential inductance values. Therefore, the interior rotor magnet array arra...

One challenge to predict output performance characteristics of switched reluctance machines (SRM) is the accurate estimation of the minimum inductance of the stator phase at unaligned position of the rotor. In this paper, boundary element method (BEM) is used for this purpose while avoiding time-consuming numerical integrations. So, the method is investigated in terms of accuracy and computatio...