The traditional means of monitoring the health industrial systems involves use vibration and performance techniques amongst others. In these approaches, contact-type sensors, such as accelerometer, proximity probe, pressure transducer temperature transducer, are installed on machine to monitor its operational parameters. However, methods fall short when additional sensors cannot be due cost, sp...

We demonstrate surface acoustic wave (SAW) induced microparticle manipulation in a microstructured disposable glass-polymer composite superstrate, positioned on a piezoelectric substrate with a single, slanted SAW transducer. An excited SAW was coupled from the piezoelectric substrate into the superstrate, which acted as a transversal resonator structure. We show that the energy transmitted int...

Pressure data acquired from multiple sites of extracorporeal circuits can be an important parameter to monitor for the safe conduct of cardiopulmonary bypass (CPB). Although previous surveys demonstrate that CPB circuit pressure monitoring is widely used, there are very little data cataloging specific applications of this practice. Therefore, the purpose of this study is to survey the perfusion...

For modern systems, wear estimation plays an important role in preventing failure, scheduling maintenance, and improving utility. Wear estimation relies on a series of sensors, measuring the state of the system. In some components, the sensors used to estimate wear may not be fast enough to capture brief transient states that are indicative of wear. For this reason it is beneficial to be capabl...

A probe consisting of a cotton thread fitted inside a 15-cm Teflon tube with an inner diameter of 0.8 mm and connected to a transducer was used to measure the interstitial pressure in the subcutaneous tissue in six anesthetized dogs. The measurements were reproducible with a standard deviation of ±0.64 mm Hg. In six dogs the mean pressure in the subcutaneous tissue of the thorax was —2.74 mm Hg...

We present a surface-mountable miniature Fabry-Perot (FP) pressure sensor that utilizes the total internal reflection at a 45 degrees angled fiber end face to steer the optical axis by 90 degrees . By using the fiber as a waveguide, as well as a natural mask in photolithography, an FP cavity is constructed on the sidewall of the fiber. A polymer-metal composite diaphragm is employed as the pres...

A probe consisting of a cotton thread fitted inside a 15-cm Teflon tube with an inner diameter of 0.8 mm and connected to a transducer was used to measure the interstitial pressure in the subcutaneous tissue in six anesthetized dogs. The measurements were reproducible with a standard deviation of ±0.64 mm Hg. In six dogs the mean pressure in the subcutaneous tissue of the thorax was —2.74 mm Hg...

The Rancho Flotation Bed provides hydrostatic support with maximum pressures over bony prominences of 15 to 25 mm Hg (measured with a pneumatic pressure transducer). This is generally below the levels normally quoted as conducive to the development of ischaemia. Clinical experience has shown the bed to be a successful aid to nursing by eliminating the need to turn the patients for pressure reas...

The monitoring of uterine activity is of importance in prenatal medicine for the surveillance of the course of the pregnancy, and for assessing the condition of the fetus. The relevant information about uterine activity can be derived from mechanical effects, such as deformation, tension in the abdominal wall, changes in intrauterine pressure, and from electrical phenomena produced by the uteru...

We used a high frequency response, ultra-thin transducer to measure forefoot pressures at predetermined sites on the sole of the foot in 10 normal subjects. We demonstrated impact pressure peaks, which have not previously been identified, and which were separate from the roll-off peak. We report preliminary results on the effect of various forms of footwear and insoles on sub-pedal pressure dur...