Abstract: In this paper a new topology of high step-down dc-dc converter is proposed. The proposed converter uses an interleaved structure with one phase using a traditional buck converter and the second phase uses its inverted version. By this technique a high step down voltage conversion can be achieved as compared to the traditional interleaved buck converter. Operating principle and steady ...

We have developed a new isolated AC/DC converter for electric vehicle on-board chargers. It consists of an AC/DC converter with Gradationally Controlled Voltage Inverter (GCVI AC/DC converter) and an isolated Zero-Voltage-Switching (ZVS) DC/DC converter, each of which is optimally controlled to convert in a highly efficient means. As a result, the new on-board charger has achieved a power conve...

2.4: (a) Load Resonant Inverter Schematic, (b) Control Circuit. 24. Fig. Voltage and current source inverter was invented before resonant inverter, but resonant. 2.1 Resonant Switching theory and converter classification. 2.2.3 Series Parallel Resonant Converter (SPRC). A.1.10 Verify resonant-circuit converter. The resonant inverters used to supply the inductor-pot system can be classified Thus...

in this paper, a dc-dc resonant converter with high voltage gain and small size is studied. to reduce the size and weight of this converter, the operating frequency should be as high as possible. in this research, the frequency changes from 120 to 200 khz. due to the high operating frequency, it is necessary to reduce the switching losses using soft switching methods. resonant converters are su...

In our paper, a method of using hybrid converter has been implemented. In the existing system, two stage approaches has been used. This two stage approach is both dc –dc converter and dc – ac Converter. This type of converters mentioned above has been used in the earlier stages, but the drawbacks that can be seen is increased cost and complexity. The proposed method mainly uses boost derived hy...

The experimental and theoretical results of a ZVS (Zero Voltage Switching) isolated flyback DC-DC converter using multilayered coreless PCB step down 2:1 transformer are presented. The performance characteristics of the transformer are shown which are useful for the parameters extraction. The measured energy efficiency of the transformer is found to be more than 94% with the sinusoidal input vo...

The object of this paper is to design and analyze a proportional – integral (PI) control for positive output elementary super lift Luo converter (POESLLC), which is the start-of-the-art DC-DC converter. The positive output elementary super lift Luo converter performs the voltage conversion from positive source voltage to positive load voltage. This paper proposes a development of PI control cap...

Ant Colony Optimization (ACO) used to tune the Proportional and Integral (PI) controller for Single Ended Primary Inductance Converter (SEPIC) is discussed in this paper. The SEPIC is based on DC to DC converter to maintain the constant output voltage but varying input voltage. PI controller maintains a constant output of the converter, without changing sign. MATLAB simulation designing is deve...

A novel zero-voltage-switching (ZVS) phase-shift isolated bidirectional DC-DC converter is proposed. It is composed of two symmetrical active-clamped circuits, one on each side of an isolation transformer. The converter can achieve full ZVS in both forward and backward modes even under noload condition. The converter also has a fast response. The operation principle and low-frequency model of t...

– A buck converter controlled by naturally-sampled constant frequency pulsewidth modulation in continuous mode of operation is analysed. For a fixed set of converter parameters and varying the dc supply voltage only the buck converter can be driven into chaos through a process of period doublings. A good agreement between simulation and experiments is obtained. Key-words: buck converter , ident...