The process of nanocontact including indentation and retraction between a large Ni tip and a Cu substrate is investigated using quasicontinuum (QC) method. The multiscale model reveals that significant plastic deformation occurs during the process of nanocontact between Ni tip and Cu substrate. Plastic deformation is observed in an area as large as 20 nm wide and 10 nm thick beneath Ni tip duri...

the brass tubes with foam cores of alsi7sic3, alsi7sic3fe1 and alsi7sic3fe3 were produced as the crush-boxes with circle and square cross-section. then axial compressive behavior and energy absorption capability of the foam-filled tubes were investigated during the quasi-static progressive plastic buckling. the uniaxial compressive stress–strain curves of the foam-filled brass tubes exhibited t...

Full-field quantitative strain maps of phase transformation and plasticity in Nitinol under large sheardominated deformation are presented. To achieve a sheardominated deformation mode with relatively uniform stresses and strains, a shear compression specimen (SCS) geometry was utilized. Shear deformation appears to impede the development of the strain localization during phase transformation t...

Equal channel angular rolling (ECAR) is a severe plastic deformation method that covered plastic deformation of sheets. In this study, effects of ECAR route shave been investigated on the mechanical and microstructure properties of explosive-welded Al-Cu bimetal. At first, the explosive welding process has been performed to prepare the Al-Cu bimetals. Then, to relieve the stress and preparing o...

Equal channel angular rolling (ECAR) is a severe plastic deformation method that covered plastic deformation of sheets. In this study, effects of ECAR route shave been investigated on the mechanical and microstructure properties of explosive-welded Al-Cu bimetal. At first, the explosive welding process has been performed to prepare the Al-Cu bimetals. Then, to relieve the stress and preparing o...

AbstractIn this paper, we investigate effect of Fe–intermetallic compounds on plastic deformation of closed-cell composite Aluminum Foam as filler of thin-walled tubes. However, deformation of the Aluminum foam-filled thin-walled tubes as crushed-box will be presented in Part (II). Composite foams of AlSi7SiC3 and AlSi7SiC3-(Fe) as closed cell were synthesized by powder metallurgy foaming metho...

In situ deformation studies of polycrystalline materials using diffraction are an established method to understand elastic and plastic deformation of materials. Studies of active deformation mechanisms, the interplay of deformation with texture and ultimately the development of predictive capabilities for deformation modeling are an active field of research. Parameters studied by diffraction ar...

In this study, dynamic behavior of safety mechanism of a mechanical controller is investigated using 3D-FE simulation. This paper is concentrated on controller of a high acceleration projectile. The controller is located in the top of the projectile. Safety mechanism is divided to deformable and rigid parts. Deformable and rigid parts are simulated in Abaqus and Adams commercial soft wares; res...

Tubular channel angular pressing (TCAP) is a recently invented novel severe plastic deformation technique for producing UFG tubes. Plastic deformation analysis using the finite element method (FEM) was carried out to investigate the effects of trapezoidal channel geometry on strain inhomogeneity index (SII), strain level and required load compared to previously used channel geometries. The resu...