An optical configuration employing two conventional Michelson interferometers and a fiber Fabry-Perot interferometer connected in parallel is used to demonstrate the principle of common mode rejection of both the amplitude and frequency noise of a semiconductor laser. Common mode noise rejection is maximized when the outputs of the two interferometers with matched path imbalance, fringe visibil...

Underwater ultrasonic transmissions for fluid-solid and air-solid phononic brass plates are reported in this work. Although the structure is roughly the same, experimental results show very different behaviour between fluid-solid and air-solid phononic plates, due to most of the properties of the fluid-solid perforated plates rely on Fabry-Perot resonances, Wood anomalies and Lamb modes. In air...

We propose a method for in situ measurement of the length of kilometer size Fabry-Perot cavities in laser gravitational wave detectors. The method is based on the vernier, which occurs naturally when the laser incident on the cavity has a sideband. By changing the length of the cavity over several wavelengths we obtain a set of carrier resonances alternating with sideband resonances. From the m...

A new design of a plane mirror Fabry-Perot interferometer with the mirror blanks freely supported by horizontal rings is described. Special attention is paid to the surface flatness and dielectric coatings of the mirrors. It is shown that any two piezoelectrically scanned Fabry-Perot interferometers can be synchronized in tandem operation using simple optics and standard electronic driving and ...

A fiber-optic Fabry-Perot interferometer was constructed by splicing a short length of photonic crystal fiber to a standard single-mode fiber. The photonic crystal fiber functions as a Fabry-Perot cavity and serves as a direct sensing probe without any additional components. Its pressure and temperature responses in the range of 0-40 MPa and 25°C-700°C were experimentally studied. The proposed ...

We show a unique dual-wavelength external-cavity laser diode with frequency tracking capability and obtain a stable beat frequency between the dual-wavelength output. By using a Fabry–Perot interferometer as the frequency discriminator and the time-gating technique in a servo loop, the peak-to-peak frequency fluctuations were stabilized, with respect to the Fabry–Perot cavity, to 86 kHz in the ...

We present airborne measurements of a novel eye-safe spectrally broadband LIDAR capable of dealing with the atmospherically-induccd variations in CO2 absorption using a Fabry-Perot based detector. The Fabry-Perot solid etalon in the receiver part is tuned to match the wavelength of several CO2 absorption lines simultaneously. The broadband technique tremendously reduces the requirement for sour...

A radio-on-dense-wavelength-division-multiplexing (DWDM) transport system based on injection-locked Fabry-Perot laser diodes (FP LDs) with four microwave carriers and large effective area fiber (LEAF) transmission was proposed and demonstrated. Good performance of bit error rate (BER) and intermodulation distortion to carrier ratio (IMD/C) over a-50 km of LEAF was obtained. Signal quality meets...

An array of subwavelength slits in a metallic substrate supports a series of Fabry-Perot-like resonances, where each harmonic results in a transmission peak. Addition of extra slits per period yields a compound grating with a structure factor associated with the basis. In this study each repeat period is comprised of a central slit flanked by a pair of narrower slits. It supports three resonanc...

We describe a software package used at the Special Astrophysical Observatory of the Russian Academy of Sciences to reduce and analyze the data obtained with the Fabry-Perot scanning interferometer. We already described most of the algorithms employed in our earlier Paper I (Moiseev, 2002). In this paper we focus on extra procedures required in the case of the use of a high-resolution Fabry-Pero...