Gold films on poly(dimethylsiloxane) (PDMS) have applications in stretchable electronics, tunable diffraction gratings, soft lithography and as neural interfaces. The electrical and optical properties of these films depend critically on the morphology of the gold. Therefore, we examine qualitatively and quantitatively the factors that affect the morphology of the gold film. Three morphologies c...

This paper proposes a method called Jump method for optimization of optical thin films. The method is the combination of local search strategy using modified Coordinate-Wise Algorithm and global search strategy using modified Evolutionary Algorithm. Jump method can evolve the designs of optical thin films for good performances. The design of a dielectric beam splitter and an edge filter as exam...

We use a laser high-harmonics-based extreme-ultraviolet (EUV) polarimeter to determine the optical constants of elemental uranium in the wavelength range from 10 to 47 nm. The constants are extracted from the measured ratio of p-polarized to s-polarized reflectance from a thin uranium film deposited in situ. The film thickness is inferred from a spectroscopic ellipsometry measurement of the sam...

The transmittance values measured in IR reflection-absorption (RA) spectra were used to determine the optical constants of dielectric films laid on solid substrates. When the recorded spectra show interference fringes, one can determine the film thickness. The PbSe film thickness was obtained by interpreting the interference fringes from the reflexion-absorption IR spectra recorded at two diffe...

The correlation between the optical properties and composition of lithium niobate films is investigated in films deposited by laser ablation of single-crystal LiNbO3 and Li enriched LiNbO3 sintered targets under different oxygen pressures and laser fluences. The results show that the variation of the film refractive index is in many cases related to the deposition process itself, rather than to...

Significant opportunities exist for optical interconnections at the board, module, and chip level if compact, low-loss, high-data-rate optical interconnections can be integrated into these electrical interconnection systems. To create such an integrated optoelectronic/electronic microsystem, mask-based alignment of the optical interconnection waveguide, optoelectronic active devices, and interf...

A low-cost, high-sensitivity humidity sensor based on a low-loss dielectric thin film waveguide (WG) is presented. The guided mode is produced by coupling laser light into the film by optical tunneling through a solid gap deposited on the base of a semi-cylindrical lens. The light reflected from this optical system carries information about the refractive index of the medium neighboring the WG,...

An optical absorbance technique was used to study the burning temperature and burning mechanism of vertically aligned single-walled carbon nanotube (VA-SWNT) films. Use of this simple optical method is shown to be consistent with the standard thermogravimetric analysis (TGA) method, but can be applied to a very small amount of SWNTs. Experimental results indicate burning of the VA-SWNTs is not ...

The design methodology and realization of nanocomposite films aiming for mechanical (superhardness, toughness) and functional (optical, microelectronic) properties were discussed in this paper. Superhard TiCrCN and nc-TiN/a-SiNx films and super-tough nc-TiC/a-C(Al) films were prepared through co-sputtering method by optimal design of microstructure. The nanocrystalline silicon (nc-Si) passivate...

The thermodynamics of the rapid vaporization of a liquid on a solid surface heated by an excimer laser pulse is studied experimentally. The transient temperature field is measured by monitoring the photothermal reflectance of an embedded thin film in nanosecond time resolution. The transient reflectivity is calibrated by considering a temperature gradient across the sample based on the static m...