BACKGROUND The objective of this study is to analyse the effectiveness of the surgical torque limiter during operative use. The study also investigates the potential differences in torque between hand and drill-based screw insertion into locking plates using a standardised torque limiter. METHODS Torque for both hand and power screw insertion was measured through a load cell, registering 6.66...

We describe a Fourier-based method of separating bars from spirals in near-infrared images. The method takes advantage of the fact that a bar is typically a feature with a relatively fixed position angle and uses the simple assumption that the relative Fourier amplitudes due to the bar decline with radius past a maximum in the same or a similar manner as they rose to that maximum. With such an ...

We describe a Fourier-based method of separating bars from spirals in near-infrared images. The method takes advantage of the fact that a bar is typically a feature with a relatively fixed position angle, and uses the simple assumption that the relative Fourier amplitudes due to the bar decline with radius past a maximum in the same or a similar manner as they rose to that maximum. With such an...

OBJECTIVE The aim of this study was to investigate whether obstructive sleep apnea (OSA) alters the fluctuation of submaximal isometric torque of the knee extensors in patients with early-grade osteoarthritis (OA). METHOD The study included 60 male volunteers, aged 40 to 70 years, divided into four groups: Group 1 (G1) - Control (n=15): without OA and without OSA; Group 2 (G2) (n=15): with OA...

The purpose of this investigation was to describe and examine variations in maximal torque produced by knee extension, knee flexion, elbow extension, and elbow flexion through a range of joint motion. Subjects were young, healthy men (n = 16) and women (n = 15). Torque was measured isometrically and isokinetically using a modified Cybex apparatus. Isotonic torque was calculated from a one-repet...

The design of a hybrid stepper motor for achieving a specific performance necessitates the choice of appropriate tooth geometry. In this paper, a detailed account of the results of twodimensional and three-dimensional finite-element (FE) analyses, conducted with different tooth width/tooth pitch ratios (t/X) and also with various tooth/slot shapes such as rectangular, trapezoidal, triangular, a...

The simple structure, low manufacturing cost, rugged behavior, high torque per unit volume and wide torquespeed range make switched reluctance motor (SRM) very attractive for industrial applications. However, these advantages are overshadowed by its inherent high torque ripple, acoustic noise, and difficulty to control. The controlled parameters in SRM drives can be selected as the turn-on angl...

In vivo measurements of maximum voluntary force – velocity show differences to the in vitro tetanic profile, with eccentric forces not increasing much above isometric and tending to decline with increasing lengthening velocity. Using transcutaneous electrical stimulation maximal eccentric torque has been found to be 1.4 times the isometric value and does not drop off at higher eccentric velocit...

Nowadays the use of the Switched Reluctance Motors (SRMs) has been considerably increased in various home and industrial applications. Despite of many advantages of this type of motors, such as simple structure, low cost, and high reliability, the main disadvantage of them is the generation of high torque pulsation. This paper presents a novel method to optimize a typical SRM such that the torq...

BACKGROUND Fatigue increases the likelihood of developing work-related musculoskeletal disorders and injury. Due to the physiological and neuromuscular changes that accompany obesity, it may alter the fatigue development mechanism and exacerbate injury risk. The upper extremities have the highest incidence rates for work-related musculoskeletal disorders. Therefore, the goals of this study were...