In the present paper, we focus on how irrelevant implicit spatial information is processed. By irrelevant we mean information that is not required to fulfill the task and by implicit we mean information that is not directly available in the external stimulus. A good example of a task in which such information exists is the SNARC task [Dehaene, S., Bossini, S., & Giraux, P. (1993). The mental re...

This paper presents a HW/SW co-design methodology for the design of resource limited embedded devices. The design methodology takes advantage of system abstraction and attached vertical and horizontal co-design flows. The vertical co-design flow focuses on a system consisting of a standard processor and a custom hardware as co-processor. The horizontal co-design flow implements the system’s fun...

Structural damage to r.c. buildings located in a near-fault area has been observed during strong ground motions, with long-duration horizontal pulses and high values of the ratio between the peak value of the vertical acceleration and the analogous value of the horizontal acceleration. The design provisions of current seismic codes are generally not very accurate for assessing the structural ef...

The effective parameters that influence in situ cast ferroTic composites were investigated. Centrifugal casting of specimens was carried out using ceramic & metallic molds. OM, SEM and XRD techniques were used to examine the existence of flows in the specimens. Results show that the control of chemical composition, processing, cooling rate and heat treatment has &#10a promising effect on the qu...

Reaction times are usually faster when stimulus and response occur at the same location than when they do not, even if stimulus location is irrelevant to the task (Simon effect). This effect was found with both horizontal and vertical stimulus-response arrangements. The same mechanisms have been proposed to be involved in either case. Here, we compared a horizontal and a vertical Simon task by ...

This paper employs one-dimensional numerical ground response analysis models to investigate seismic response of shallow cohesive and non-cohesive soil deposits on vertical propagation of horizontal shear waves. Soil response is modelled by traditional equivalent-linear (EL) frequency-domain analysis using DEEPSOIL software and nonlinear (NL) time-domain analysis using OPENSEES software. The ana...

Cavitation is one of the most well-known process faults that may occur in different industrial equipment especially centrifugal pumps. Cavitation also may happen in water pumps and turbines. Sometimes cavitation has been severe enough to wear holes in the impeller and damage the vanes to such a degree that the impeller becomes very ineffective. More commonly, the pump efficiency will decrease s...