Existing analytical thermal models for predicting surface burns due to grinding have limited use because of their reliance on parameters that are not readily obtainable in practice. This paper presents a practical and consistent fuzzy rule-based model for estimating the grinding conditions at which ‘‘burn limits’’ occur. The model consists of 37 absolute and eight relative rules. It has a wide ...

Mechanochemistry is maturing as a discipline and continuing to grow, so it is important to continue understanding the rules governing the system. In a mechanochemical reaction, the reactants are added into a vessel along with one or more grinding balls and the vessel is shaken at high speeds to facilitate a chemical reaction. The dielectric constant of the solvent used in liquid-assisted grindi...

In this study, it is experimentally investigated that the surface generation process in the cross axis grinding method with small diameter grinding wheel. In this grinding method, workpiece surface speed and sum of both wheel working surface speed and wheel feed rate crossed each other. Therefore, it is the largest characteristic that the cross angle, which is defined as the angle between the w...

The grinding is one of the most important methods that directly affects tolerances in dimensions, quality and finished surface of products. One of the major problems in the material removal processes specially grinding is the heat generation during the process and the residual tensile stress in the surfaces of product. Therefore, optimization of High Efficiency Deep Grinding (HEDG) process is t...

Conventional material removal of BK7 optical glass will normally result in brittle fracture at the surface, generating severe subsurface damage and poor surface finish. Subsurface damages induced by grinding strongly influence the mechanical strength and optical quality of optical glasses. However, through ductile mode grinding it is possible to reduce the surface and subsurface cracks. It is m...

Abrasive machining in general and grinding in particular are processes, which increase their importance with high demands on accuracy of surface finish. The chip thickness is an evaluating variable to describe the quality of ground surface as well as the performance of the overall grinding system. A significant characteristic that distinguishes ceramics from metals is their low fracture toughne...

Abstract Canadian gum, epoxy resin, and emery are used in the production of general rock thin section materials. These materials have fluorescence, so it is not possible to make fluorescent sections. The use other colloids or transparency good, because abrasive will also lead specimen having which cannot be selected. At present, 502 usually sheet adhesive China, but colloid soluble water impact...

The purpose of this study was to evaluate the effect of degradation of a denture base resin on bond strength to relining resins. Denture base resin specimens were immersed under various conditions to simulate degradation. Tensile bond strength of denture base resin after immersion to relining resins was measured with or without surface grinding. The bond strength of denture base resin without g...

This paper focuses on the development of high temperatures in the cutting zone during high performance grinding. In order to identify the infl uence of grinding temperature on surface integrity, temperatures were measured in the workpiece surface layer under diff erent machining conditions. Beside this, under the same conditions, the surface layer properties of the workpiece material were deter...

simulation of grinding circuits has being performed from 30 years ago and is also to be more complete and powerful approach with improvement of mathematical models which simulate various processing units/machines. the modeling and simulation of various mineral processing circuits are presently performed. in order to simulate the present grinding circuits of esfordi phosphate processing plant, a...