The presented work introduces a numerical parametric study on the crack propagation direction under mixed-mode conditions (mode I + II). It is conducted for the geometry of an eccentric asymmetric fourpoint bending of a single edge notched beam specimen; various levels of mode-mixity are ensured by modifications in the crack length and crack eccentricity. The direction of crack propagation is e...

Fatigue properties and cracking behavior of cold-drawn commercially pure aluminum wires (CPAWs) widely used as the overhead transmission conductors were investigated. It was found that the fracture surface of the CPAWs shows an obvious four-stage fracture characteristic, i.e., crack initiation, planar crack propagation, 45°-inclined crack propagation and final rapid fracture. The crack growth m...

This paper describes work to study hot corrosion damage in the nickel-based gas turbine alloy RR1000 coated with various salts at 600 °C. Interest type-II on fatigue resistance of alloys has increased minimise power/thermal inefficiencies. Stress-free demonstrated a greater impact sulphate (versus chloride) maximum pit depth, key influencing factor lives. In corrosion-fatigue testing, low stres...

Nowadays total joint replacements are widely used in the world, so in average 800,000 joint surgeries are done yearly only in Europe and North America. However implant loosening is and remains as the major issue of all implant failures and therefore causes revision surgery procedures. Studies and experiments have identified poor fixation of implants most likely is the main cause of long term im...

Dense Silicon nitride was investigated to determine the effect of its microstructural parameters and densification on thermo-mechanical properties and thermal stress resistance to fracture initiation during a hot or cold mechanical and thermal shock testing. The different materials and microstructures were obtained by changing the parameters such as the type of the powder, additive, forming p...

Since the sub-axis of machine tool spindles subjected to fatigue loading, the effects of different surface heat treatments on fatigue behavior of 16MnCr5 steel have been investigated in the current work. After the test specimens were prepared from the steel, the surface heat treatments; carburizing, carbonitriding and a practical type of treatment involving the first nitriding then carburizing ...

Crack initiation mechanisms under two stress ratios (R = ? 1 and 0.5) up to very-high-cycle fatigue (VHCF) regime of a selective laser melted (SLMed) Ti-6Al-4V were investigated. Type I lack-of-fusion defects (almost equiaxed) induced crack except for the cases VHCF R 0.5 in which type II (large aspect ratio) caused facet mode initiation. A nanograin layer formed underneath region rough area at...

BACKGROUND An aortic aneurysm is a local dilation of the aorta, which tends to expand and often results in a fatal rupture. Although larger aneurysms have a greater risk of rupture, some small aneurysms also rupture. Since the mechanism of aortic rupture is not well understood, clarification of the microstructure influencing the failure to rupture is important. Since aortic tissues are stretche...