Fouling is the most important performance degradation factor, so it is necessary to accurately predict the effect of fouling on engine performance. In the previous research, it is very difficult to accurately model the fouled axial flow compressor. This paper develops a new performance calculation method of fouled multistage axial flow compressor based on experiment result and operating data. F...

This paper describes modeling and simulation of air compressor energy use to estimate energy savings in compressed air systems from air use reduction and other changes. The method uses measured power signatures and other compressor parameters as inputs to calculate various performance metrics and estimate energy savings. To enable recognition of control mode from measured power data, examples o...

Recent interest in natural refrigerants has created a new impetus for studies of CO2 as a working fluid in vapour compression systems for refrigeration and air conditioning. Two major drawbacks to its use are the very high pressure differences required across the compressor and the large efficiency losses associated with the throttling process. One of potential advantages of screw machines over...

Electrical on demand supercharging provides an internal combustion engine with the facility to increase its volumetric efficiency without being subject to the mechanical constraints associated with a conventional pressure charging device. This enables improvement in fuel economy through engine downsizing with the added ability to enhance torque. The Visteon Torque Enhancement System (VTES) is a...

As a result of research done in the early '70's on the loss mechanisms and causes of failure in compressor valves, a new line of valves was designed and developed, The new line of valves has losses less than one-third the losses in earlier valves and is also more reliable. This paper outlines the basis for the improvements in efficiency and reliability, and describes the development process lea...

This paper presented the theoretical and experimental investigation on ring valve motion and impact stress in a reciprocating compressor for a purpose of extending the life time of valve. A simulation model was established to describe the motion of valve plate and the physical behavior of valve plates during compressor operation was measured using an eddy current displacement sensor to validate...

There are two kinds of dual split type air-conditioner. One is of using two compressors for two indoor units; the other has only one compressor for two indoor units. The EER and refrigerating capacity of the former kind are just the same as the single split type's. But to one compressor dual split type system, there are two working ways: 1. compressor and both two indoor units operating, and 2....

Structural steels with very high strength levels are often referred to as ultrahigh-strength steels (UHSS). The usage of UHSS has been extensively studied in aerospace industries and offshore platforms. In this study, medium carbon low alloy steel (AMS6305) was thermomechanicaly treated to obtain an ultra-high strength bainitic steel for aircraft engine compressor disk. A novel themomechanical ...