In this study, functionally graded Ni-Al2O3 composite coating (FGN-A) has been produced from nickel Watt’s bath containing different concentrations of Al2O3 particles. For this, different composite coatings were electroplated in the same bath with different particles concentration to find the optimum concentration of particles in which the maximum content with uniform distribution of Al2O3 part...

the effects of a nano-emulsion chitosan-based coating on enhancing the shelf-life and quality of golab kohanz apples were studied. the nano-emulsion coating containing chitosan with a concentration of 2000 ppm was applied for coating of golab kohanz apples. coated and uncoated apples were packed in normal packaging cardboards and kept at 2 ± 1 °c with a relative humidity within 80-85%. flesh fi...

Abstract Polytetrafluoroethylene (PTFE) polymer is used extensively in industry as a solid lubricant because of its lack reactivity with most industrial materials. However, PTFE has low abrasive resistance, limiting application. In this study, the mechanical and tribological characteristics PTFE-based composites addition clay nano-sheets (CNSs) were investigated. Clay nano-sheet-PTFE (CNSTCs) c...

The influence of TiO2 nano-particles (nano-TiO2) was studied relative to the mechanical and optical properties of CMYK printed paperboard after coating with a UV-curable varnish. Commercial duplex paperboard (glazed grayback paperboard, 230 g/m) was printed with a CMYK offset printing process. Board samples were coated with a nano-TiO2 modified UV-curable varnish at four treatment levels (0, 0....

ticl4, ammonia, inorganic salts as raw material, nanometer composite-crystal tio2 powders were synthesized by two-step chemical method. precursors were crystallized with different phase and stable composite-crystal tio2 with anatase and rutile phase was prepared at low temperature. quantitative control of crystal phase was realized. remarkable factors including reaction ph value, reaction time,...

the synthesis of titania via sol-gel method has been widely studied. in the present work, titania was deposited onto a titanium substrate via sol-gel method. different processing parameters such as the repetition number of dipping/heat treatment process and dipping time have been studied to obtain the homogenous titania coating. phase and microstructural evaluation of the powder and coating sam...

In previous study, dense and homogenous 20wt% HAP/Ti composite coatings were successfully deposited on Ti substrates by cold gas dynamic spray technique. The results revealed that the phase composition of the HAP in the deposit is identical to that of the precursor powder and the bonding strength of the deposit is comparable/better to that of the plasma sprayed HAP. A relatively higher corrosio...

introduction: essential oils are used as flavoring agents in various foods. layer-by-layer (lbl) technique is a method in which the material is dipped into a series of different solutions containing oppositely charged polyelectrolytes. the aim of this study is to investigate the effectiveness of a multilayered edible coating with an antimicrobial compound (lemon and peppermint) in enhancing the...

The osmotic dehydration causes water removing from food and also a soluble solid uptake into thefoodstuffs. However, large penetration of solute into the food becomes a major problem in osmoticdehydration.Pre-coating the food to be dehydrated with an artificial, edible barrier was also explored as a wayto efficiently hinder solute penetration. In this study the effect of edible coating (CMC),co...