this paper presents a new method called vespiary regular hexagonal (vrh) model to calculate parasitic capacitance between conductor wire filaments of one turn of a coil and between conductor wires filament and liner and also total capacitance of n-turns having single-layers, multi-conductor wire filaments of the helix magneto cumulative generator (mcg) coil. the presented method is an analytica...

A voltage transformer, as voltage signal detection equipment, plays an important role in a power system. Presently, more and more electric power systems are adopting potential transformer and capacitance voltage transformers. Transformers are often large in volume and heavyweight, their insulation design is difficult, and an iron core or multi-grade capacitance voltage division structure is gen...

ALD Al2O3/GaAs and Al2O3/In0.2Ga0.8As MOS and source-drain implanted MOSFET structure were fabricated and characterized by capacitance-voltage (CV) and current-voltage (I-V) measurements. It is shown that, after high-temperature anneal, the MOS leakage current density of the thinner (16nm) film is much higher than that of the thicker (30nm) film. The highquality Al2O3 (30nm)/In0.2Ga0.8As interf...

A digital capacitance meter is a piece of electronic test equipment used to measure capacitance mostly of discrete capacitors. This project presents the design and implementation asynchronous digital capacitance meter using principle that when capacitor is connected across constant DC source, it charges at an exponential rate which dependent on seen by source as well resistance in circuit. In t...

In this paper we present a new model for calculating the capacitance of MEMS sensor with corrugated diaphragm. In this work the effect of residual stress is considered on deflection of diaphragm and capacitance of sensor. First, a new analytical analyzes have been carried out to derive mathematic expressions for central deflection of corrugated diaphragm and its relationship with residual stres...

A capacitor-type engine oil sensor is designed and fabricated to measure the property of diesel depending on vehicle mileage. This has flat structure with interdigitated (IDT) electrodes for smooth flow constructed using printed circuit board (PCB) fabrication convenience. For increased capacitance, smaller spacing between preferred determined 0.5 mm based limit. The device applied actual truck...

For evaluating quality of electrical insulation, it is necessary to measure the property of insulators. Dielectric constant and loss tangent (tans) are two important parameters for determining the property of insulator. The measurement of above parameters is normally based on the time- domain and frequency-domain, which is costly and time consuming. In this study a multiple-frequency binary se...