The use of a diabetic blood glucose meter for radiochromic film dosimetry in blood irradiation using x-ray beams on a medical linear accelerator has been investigated. The glucose meter provides optical density analysis in the visible and infrared region using a reflectance measurement technique. By comparing the 'blood sugar' level output with standard calibration gafchromic films a calibratio...

This paper theoretically derives a general rule that while the slope of the semi-logarithmic plot (Y vs. log X) of a calibration curve varies depending on analyte concentration, X, the slope takes a specific value at the detection limit (L(D)). This rule holds good irrespective of the shape of the calibration curve (linear or non-linear) and in this paper, is applied to competitive ELISA (enzym...

This paper proposes a calibration algorithm that fits multi-factor Gaussian models to the implied volatilities of caps using the respective minimal consistent family to infer the forward rate curve. The algorithm is applied to three forward rate volatility structures and their combination to form two-factor models. The efficiency of the consistent calibration is evaluated through comparisons wi...

Radiometric cross-calibration between the Advanced Spaceborne Thermal Emission and Reflection Radiometer (ASTER) and the Terra-Moderate Resolution Imaging Spectroradiometer (MODIS) has been partially used to derive the ASTER radiometric calibration coefficient (RCC) curve as a function of date on visible to near-infrared bands. However, cross-calibration is not sufficiently accurate, since the ...

The quantitation of target analytes in complex matrices such as biological samples requires special calibration approaches to compensate for additional capacity or activity in the matrix samples. A conventional calibration curve, obtained with standard solutions, is one of the most important calibration procedures for quantitation of target analytes in such matrices. However, these technique re...

PURPOSE The purpose of this study was to verify the influence of individual calibration on sound tooth surfaces and the number of readings on in vitro performance of a laser fluorescence (LF) device to detect occlusal caries in primary teeth. METHODS After standard calibration (on the porcelain reference object), 72 clinically suspect sites on occlusal surfaces of 54 exfoliated or extracted (...

Caffeine is a natural substance present in leaves and seeds of many plants. The aim of this study is to evaluate the caffeine level in the carbonated drinks from the Romanian market. For this survey were taken 30 samples of different carbonated drinks. The caffeine was determined and quantified using a HPLC with diode array detector at 206 nm. The caffeine retention time was at 17.785 minutes. ...

This study evaluates the suitability of flow cytometry with the fluorochrome BCECF for measuring the intracellular pH (pHi) of cultured cells, and monitors the changes in pHi in murine hybridoma in batch culture and chick embryo fibroblast in monolayer culture (5th passage). The technique produced highly reproducible, repeatable results. The theoretical sensitivity from the calibration curve wa...

Fully automated microparticle enzyme immunoassays (MEIA) for the IMx immunoassay analyser were developed to detect IgG and IgM antibodies to Toxoplasma gondii. The IgG MEIA results are expressed in International Units (IU) of IgG antibody interpolated from a six point calibration curve covering the range from 0 to 300 IU/ml. Reproducible results were obtained from a calibration curve stored in ...

Ochratoxin A (OTA) is a type of mycotoxin generated from the metabolism of Aspergillus and Penicillium, and is extremely toxic to humans, livestock, and poultry. However, traditional assays for the detection of OTA are expensive and complicated. Other than OTA aptamer, OTA itself at high concentration can also adsorb on the surface of gold nanoparticles (AuNPs), and further inhibit AuNPs salt a...