The airconditioning systems of buildings have been diversified in recent years, and the complexity of the system has been increased. At the same time, stability in the system and the low-running cost are demanded. To solve these problems, various researches have been done. The development of the energy load prediction systems and the faults detection and diagnosis systems have received greater ...

The possibility of building a high voltage electrostatic air pump for cooling of microelectronics is investigated. Existing cooling technology no longer provides adequate heat dissipation due to excessive heat generation caused by the growing component density on electronic devices. Heat sink fins are packed more closely to increase the heat exchange surface area, resulting in narrower channels...

High power density outer-rotor motors commonly use water or oil cooling. A reasonable thermal design for outer-rotor air-cooling motors can effectively enhance the power density without the fluid circulating device. Research on the heat dissipation mechanism of an outer-rotor air-cooling motor can provide guidelines for the selection of the suitable cooling mode and the design of the cooling st...

The main objective of this study was to develop a thermoelectric heat pump and liquid desiccant system based on a dedicated outdoor air system (THPLD-DOAS). An internally-cooled and -heated liquid desiccant system was used and a thermoelectric heat pump (THP) served as the desiccant cooling and heating energy source for dehumidification and regeneration of the desiccant solution, respectively. ...

complex heat transfer phenomena (including unsteady state conduction, convection and solidification processes) occur in steel belt conveyer sulfur granulating method. numerical simulation of this technique is performed via a comprehensive and multifaceted one dimensional model. since the air situated between the adjacent sulfur pastilles is essentially stagnant, therefore, the surface temperatu...

This paper presents an in-depth system-level experimental analysis comparing air-cooled and liquid-cooled commercial off-the-shelf (COTS) electric motors. Typically, liquid-cooled electric motors are reserved for large, expensive, high-end applications where the design of the motor’s electromagnetic components are closely coupled to its cooling system. By applying liquid cooling to a pre-existi...

Air film cooling has been widely employed to cool gas turbine hot components such as combustor liners, combustor transition pieces, turbine vanes and blades. Enhancing air film cooling by injecting mist with tiny water droplets with diameters of 5-10μm has been studied in the past on flat surfaces. This paper focuses on computationally investigating the curvature effect on mist/air film cooling...

Description Background – In recent times there is a notable increase in research towards compact, high heat flux, dedicated cooling solutions for electronic systems. This is due to an ever increasing power density of these electronic components that needs to be dissipated. Conventional cooling using finned heat sinks with air is inadequate to keep up with these increasingly stringent cooling de...