In an inductively-coupled H2-Ar plasma at a total pressure of 1.5 Pa the influence of the electrode cover material on selected line intensities of H, H2, and Ar are determined by optical emission spectroscopy and actinometry for the electrode cover materials stainless steel, copper, tungsten, Macorr, and aluminum. Hydrogen dissociation degrees for the considered conditions are determined experi...

Fracture fixation of the medial malleolus in rotationally unstable ankle fractures typically results in healing with current fixation methods. However, when failure occurs, pullout of the screws from tension, compression, and rotational forces is predictable. We sought to biomechanically test a relatively new technique of bicortical screw fixation for medial malleoli fractures. Also, the AO gro...

To measure the cleanability of stainless steel surfaces under standardized conditions, a test stand was set up. Three stainless steel plates (size 200 x 100 mm) can be fixed to the test stand and sprayed with a water jet from a low-pressure nozzle for a period of several minutes. The plates were previously soiled with a starch or protein film with a pre-defined layer thickness and dried for sev...

Objectives The purpose of this study was to investigate the effect of different types of toothpaste on the frictional resistance between stainless steel brackets and archwires. Materials and Methods Ninety stainless steel orthodontic brackets with stainless steel wires were bonded to bovine teeth and were divided into 6 groups for application of the following toothpastes: Colgate® Total® Adva...

Poly (ethylene glycol) (PEG) molecules attached to surfaces have shown high potential as a protein repellent due to their flexibility and highly water solubility. A quartz crystal microbalance recording frequency and dissipation changes (QCM-D) has been used to study the adsorption from aqueous solutions, of lysozyme and α-lactalbumin proteins (the last with and without calcium) onto modified s...

304 stainless steel was tested under the media without Sulfate-reducing bacteria (SRB) and with SRB. The corrosion behaviors of 304 stainless steel in SRB and without SRB medium were studied by measuring the open circuit potential, the polarization curves and electrochemical impedance Spectrum,weight loss measurements to get the changes of fore-and-aft corrosion fouling. The open circuit potent...

The purpose of this prospective longitudinal randomized study was to compare the clinical performance of recycled brackets with that of new stainless steel brackets (Orthos). Twenty patients treated with fixed appliances were included in the investigation. Using a 'split-mouth' design, the dentition of each patient was divided into four quadrants. In 11 randomly selected patients, the maxillary...

This work reports on the influence of β-lactoglobuline (β-LGB) and of its denaturation on the adherence of quartz particles, taken as a model of particulate soil, on stainless steel AISI 304 with mirror finish. The substrate was soiled with quartz suspensions in water or in β-LGB solutions as such or previously heated at 75°C, and dried at room temperature or in an oven at 75°C. Cleanability wa...

A previously-developed experimental facility has been used to determine gas-surface thermal accommodation coefficients from the pressure dependence of the heat flux between parallel plates of similar material but different surface finish. Heat flux between the plates is inferred from measurements of temperature drop between the plate surface and an adjacent temperaturecontrolled water bath. The...

In poultry industry, cross-contamination due to processing equipment and contact surfaces is very common. This study examined the extent of bacterial attachment to 6 different types and design of conveyor belts: stainless steel-single loop, stainless steel-balance weave, polyurethane with mono-polyester fabric, acetal, polypropylene mesh top, and polypropylene. Clean conveyor belts were immerse...