low carbon steel samples were both shot into and inoculated with titanium in order to improve mechanical properties such as strength and toughness. sem observations and x-ray analyses revealed that titanium nitride and titanium carbonitride precipitates being scattered in the ferrite substrate reduce the grain size in all as-cast, heat-treated and as-rolled cases. the growth of the grains at hi...

fatigue behavior of a vanadium microalloy steel has been studied in this research. here, microstructure constituents were considered which essentially are dependent on the heat treatment conditions. the results of high cycle fatigue tests revealed that heat treatment procedure and cooling rates have significant effects on fatigue properties. optimal heat treatment cycle of the microalloyed stee...

It is generally accepted that the electrochemical discharge capacity of a hydrogen storage alloy is closely related to its crystal characteristics. From our experiment, the discharge capacity of AB type Laves phase hydrogen storage alloy ZrCr Mn V Ni 2 0.4 0.2 0.1 1.3 21 21 decreased sharply from 324 mAh g to 25 mAh g after amorphization by mechanically milling the crystalline (as-cast) alloy w...

The microstructure and mechanical properties of rheo-diecasting Al−6Zn−2Mg−2Cu alloys microalloyed with Ti, Sc Sc+Zr were studied by optical microscopy (OM), scanning electron (SEM), X-ray diffraction (XRD), hardness testing, tensile testing. swirled equilibrium enthalpy device (SEED) process was introduced to prepare the semisolid slurry. Results show that addition Sc, refines grain size impro...

Recently, the grain boundary−intragranular nucleation of ferrite has received great attention seeking for the improvement of the toughness in the steel, specially when conventional austenite grain refinement techniques are not enough. This paper deals with some relevant aspects about the competitive process of allotriomorphic and idiomorphic ferrite transformations in a medium carbon vanadium-t...

S. Rešković, I. Jandrlić, University of Zagreb, Faculty of Metallurgy, Sisak, Croatia, F. Vodopivec Institute of Metals and Technology, Ljubljana, Slovenia Using thermal imaging camera during tensile testing of low carbon and Nb microalloyed steel influence of testing rate on start of plastic deformation was investigated. The results showed that the onset of plastic flow is significantly differ...

Microstructures and Charpy impact properties have been examined in two microalloyed steels following heat treatments to simulate weld heat affected zone (HAZ) structures over a range of heat input conditions, characterised by the cooling time from 800 to 500 !C (Dt8/5). The base materials were low carbon structural steel plates microalloyed with vanadium and nitrogen (V–N) and niobium (Nb), res...

a low carbon al-killed ti-added steel was produced in mobarakeh steel complex in iran. mechanical properties and microstructural characterizations of steel in the as-cast, hot-rolled, cold-rolled and annealed conditions are presented. dilatometery tests were carried out to measure the finishing and annealing temperatures of steel. it was found that the addition of small amounts of ti increased ...

In steels the dependence of ambient temperature microstructure and mechanical properties on solidification rate is not well reported. In this work we investigate the microstructure and hardness evolution for a low C low Mn NbTi-microalloyed steel solidified in the cooling rate range of 1-50 Cs-1. The maximum strength was obtained at the intermediate solidification rate of 30 Cs-1. This result h...