An incompressible potential-flow vortex method has been constructed to analyze the flow field of a ducted wind turbine following that outlined by Lewis (1991). Attention is paid to balancing the momentum change in the flow to the total longitudinal forces acting on the duct-turbine combination: the pressure force on the actuator disk plus the pressure forces acting on the duct, which typically ...

A solar chimney power plant consists of four main parts, a solar collector, a chimney, an energy storage layer, and a wind turbine. So far, several investigations on the performance of the solar chimney power plant have been conducted. Among them, different approaches have been applied to model the turbine inside the system. In particular, a real wind turbine coupled to the system was simulated...

The article investigates the effect of compressor pressure ratio, turbine inlet temperature and ambient temperature on the performance parameters of an air-cooled gas turbine cycle with evaporative cooling of inlet air. Air f ilm cooling has been adopted as the cooling technique for gas turbine blades. The mass of coolant required for turbine blade cooling is calculated f or a selected range of...

Cooling characteristics are given in terms of the variation of average blade temperature at mid-span with cooling-flow rate, Reynolds number, gas/cooling-air absolute temperature ratio, and, for the rotor, gas-stream incidence. Chordwise and spanwise variations of blade temperature are also presented. Measured pressure-drop characteristics indicate that in a gas-turbine engine, with the cooling...

electrospinning is a method of nanofiber filter media production. by this method, it is possibleto produce media with nanofiber in the range of nanometer to micrometer. nanofibrous media provide a large specific surface area in a finite volume thus they are suitable for filtration applications. in this study, nanofiber non-woven membranes production of nylon-6 by electrospinning method is inves...

the purpose of this study is to improve the aerodynamic performance of wind turbine blades, using the ball-spine inverse design method. the inverse design goal is to calculate a geometry corresponds to a given pressure distribution on its boundaries. by calculating the difference between the current and target pressure distributions, geometric boundaries are modified so that the pressure differ...

in this paper, the fluid-structure interaction phenomenon and the research history are described. then due to the complex and specific working conditions of a turbine blade, we have investigated the phenomenon on this subject. the fluid-structure interaction on a turbine blade model has been simulated by using structural and fluid flow section of ansys software. a model of turbine blade with ai...

The bypass exhaust system of a 160 MW combined cycle has been modeled and analyzed using numerical simulation in 2D prospective. Analysis was carried out using the commercial numerical simulation software, FLUENT 6.2. All inputs were based on the technical data gathered from working conditions of a Siemens V94.2 gas turbine, installed in the Yazd power plant. This paper deals with reduction of ...

This study examined the aerodynamic power output change of wind turbines with inter-turbine spacing variation for a 6 MW wind farm composed of three sets of 2 MW wind turbines using computational fluid dynamics (CFD). The wind farm layout design is becoming increasingly important as the use of wind energy is steadily increasing. Among the many wind farm layout design parameters, the inter-turbi...