A novel transient technique is developed to measure the thermal diffusivity of one-dimensional microscale wires. In this technique, a pulsed nanosecond laser is used to quickly heat the wire. After laser heating, the wire temperature decays slowly. Such temperature decay is sensed and used to determine the thermal diffusivity of the wire. A 25.4μm thin Pt wire is characterized to verify this te...

Single crystals of GdCa4O(BO3)3 were examined to determine their thermal properties. Samples were grown by the Czochralski pulling technique. There were three types of samples: a pure crystal, the crystal doped with neodymium (4 at.% of Nd), and the third one doped with ytterbium (7 at.% of Yb). All samples were rectangular prisms with edges parallel to the axes of the optical indicatrix X, Y ,...

In this study we applied thermal lens (TL) technique to study the effect of size on thermal diffusivity of cadmium sulphide (CdS) nanofluid prepared by using γ-radiation method containing particles with different sizes. In TL experimental set up a diode laser of wavelength 514 nm and intensity stabilized He-Ne laser were used as the excitation source and the probe beam respectively, respectivel...

Bismuth telluride nanowires are of interest for thermoelectric applications because of the predicted enhancement in the thermoelectric figure-of-merit in nanowire structures. In this letter, we carried out temperature-dependent thermal diffusivity characterization of a 40 nm diameter Bi2Te3 nanowires/alumina nanocomposite. Measured thermal diffusivity of the composite decreases from 9.2310−7 m2...

We introduce a general purpose penetrator, fitted with a heater, for measuring temperature and thermal diffusivity. Due to its simplicity of deployment and operation the penetrator is well suited for remote deployment by spacecraft into a planetary regolith. Thermal measurements in planetary regoliths are required to determine the surface energy balance and to measure their thermal properties. ...

This paper presents a study on estimation of heat transfer coefficient and thermal diffusivity parameters by use of analytical solutions and experimental data for regular geometries (infinite slab, infinite cylinder and sphere). Analytical solutions have a broad use in experimentally determining these parameters. These solutions, with use of experimental data, might give a greater advantage ove...

In this paper thermal conductivity and thermal diffusivity of a two layer system is examined from the theoretical point of view. We use the one dimensional heat diffusion equation with the appropriate solution in each layer and boundary conditions at the interfaces to calculate the heat transport in this bounded system. We also consider the heat flux at the surface of the samle as boundary cond...

In this study, optical and thermal properties of normal grade and winter grade palm oil biodiesel were investigated. Surface Plasmon Resonance and Photopyroelectric technique were used to evaluate the samples. The dispersion curve and thermal diffusivity were obtained. Consequently, the variation of refractive index, as a function of wavelength in normal grade biodiesel is faster than winter gr...

The extent of the change in thermal diffusivity of soft tissues due to heat-induced damage is not well known. Reported here are the results of using the flash method to measure the through-the-wall component of thermal diffusivity of bovine aorta before and after the tissue has undergone two hours of heating at 75 degrees C. The measurements indicate a 10.1 percent increase in the thermal diffu...

Possible approaches to thermal wave based measurement of thermal diffusivity are considered. The calculation of the transverse photodeflection signal in the framework of wave optics prove to be a more accurate approach compared to that of geometrical optics. The influence of the account of wave optical effects on the accuracy of the thermal diffusivity determination is theoretically analyzed un...