In this paper, four-switch inverter fed direct torque control three phase Induction Motor drive is presented. A triangular wave is used as dither signal of minute amplitude (for torque hysteresis band and flux hysteresis band respectively) in the error block. This method minimizes flux and torque ripple in a Four-Switch inverter fed induction motor drive while the dynamic performance is not aff...

To fulfill the challenging demands of the growing grid, new concepts of the inverters are needed. In this project a reduced switch modular inverter design is detailed. A reduced switch modular inverter design is presented for a modern power system which inputs power from both AC and DC Renewable Sources. The modular inverter is the combination of both three phase inverter and three phase invert...

this paper proposes a new configuration for solar energy conversion systems. one challenging issue of the photovoltaic (pv) systems is partial shading, and in this paper module integrated converters (mic) are used to overcome this problem in pv arrays. a few boost converters are employed as mics to mitigate the shading effect. furthermore, to reduce the cost and to increase the system performan...

This paper summarizes recently developed soft-switching inverters and proposes two alternative options for electric propulsion drives. The newly developed soft-switching inverter employs an auxiliary switch and a resonant inductor per phase to produce a zero voltage across the main switch so that the main switch can turn on at the zero-voltage condition. Both the auxiliary switch and the resona...

Safe operation of electric motor drives is of prime research interest in various industrial applications. This paper presents a new fault diagnosis system for open circuit switch faults in three phases Voltage Source Inverter (VSI) drive of the permanent magnet Brushless DC (BLDC) motors. The proposed fault diagnosis system is capable of detecting as well as identifying the faulty switch in the...

In this paper, two single phase ac loads are supplied with one inverter and reduced switch count topologies are introduced in this paper. It has three switch single leg structures. This single leg inverter is functionally comparable to half bridge inverter working independently though with a less number of semiconductor switch and hence control and gate drive circuit components. This three swit...

Department of Electrical Engineering, University of Engineering and Technology, Lahore, Pakistan Contact: : [email protected] [email protected] [email protected] ABSTRACT: This paper presents the sensor-less control of a PMSM using extended Kalman Filter and a four switch three phase inverter implemented using FPGA Spartan 3-e. The system was modeled in Matlab/Simulink® and ver...

This article proposes a topology for construction of multilevel inverter consisting of H-bridge and level switch. In accordance with the proposed topology Н-bridge inverts voltage and a switch enables to get any number of voltage levels. At that, in comparison with analogues, the above mentioned topology allows saving on expensive power keys. Moreover, a special technique has been developed to ...

The class Φ2 inverter is a new switched mode type of resonant inverter. This inverter is applicable for very high frequency application. In this paper, it proposes class Φ2 inverter reduced the voltage stress, and improve the dynamic response. The class E resonant inverter is not suitable for high frequency application, because it produce high voltage stress across the switch. The suitable ball...