The essence of the pneumo-mechanical spinning method lies in transformation tape into a discrete stream fibers, formation wedge-shaped ribbon from this form an open end groove chamber and yarn by torsion, which is removed wound bobbin. Yarn obtained on rotor machine differs structure ring machines, it has lower breaking load produced with higher filling twist.

The article is devoted to the study of properties yarn obtained by methods ring and rotor spinning, for twisted yarn, produced on a VTS-09 double twist machine made Volkmann (Germany). Experiments were carried out two typesof spinning yarns with counts Ne 20/2 12/2 in existing design (control) new design, flexible element equal tension intensifier compared effects resulting quality parameters. ...

A micromachined gyroscope in which a high-speed spinning rotor is suspended electrostatically in a vacuum cavity usually functions as a dual-axis angular rate sensor. An inherent coupling error between the two sensing axes exists owing to the angular motion of the spinning rotor being controlled by a torque-rebalance loop. In this paper, a decoupling compensation method is proposed and investig...

This paper proposes a new concept for attitude actuation for small satellites that uses active magnetic bearings to support and tilt a spinning rotor to provide 3-axis attitude control of the satellite using a single actuator. A controlled 3D motion in the spinning rotor provides a conventional torque output about the momentum axis and a gyroscopic torque output about any direction in the plane...

most of the methods that have been proposed for speed estimation of induction machines require the rotor and the stator resistance to change in the normal operating range. on the other hand, estimation of the rotor resistance requires rotor speed. in this paper, after studying conditions for simultaneous estimation of rotor speed and rotor resistance, a method for simultaneous estimation of rot...

A theory of dynamic angle spinning (DAS) and double rotation (DOR) NMR is described using average Hamiltonian and irreducible tensor methods. Sideband intensities in DAS and DOR spectra are analyzed by both the moment and Bessel function methods, and general formulae are derived. Results show that the DAS moments depend on the relative rotor phase between the first and the second evolution peri...

This paper proposes a new concept for attitude actuation for small satellites that uses active magnetic bearings to support and tilt a spinning rotor to provide 3-axis attitude control of the satellite using a single actuator. A controlled 3D motion in the spinning rotor provides a conventional torque output about the momentum axis and a gyroscopic torque output about any direction in the plane...

The current paper describes the design and fabrication of a micromachined electrostatically suspended gyroscope. Electrostatic levitation is employed to suspend the rotor, eliminating the mechanical bearing and thus friction effects between the rotor and the substrate, hence improving long-term stability. The rate of rotation can be measured by detecting the torque-induced displacement of the s...

This paper presents the micromixing times in a rotor-stator spinning disc reactor. Segregation indices are obtained at different rotational speeds performing the Villermaux-Dushman parallel-competitive reaction scheme. Consequently, the corresponding micromixing times are calculated using the engulfment model, while considering the self-engulfment effect. It was found that the segregation index...