This paper represents the performance of a squirrel-cage High Temperature Superconducting Induction/ Synchronous Motor (HTS-ISM) based on nonlinear electrical equivalent circuit. The structure of the HTS-ISM is the same as that of the squirrel-cage type induction machine, and the secondary windings are fabricated by the use of the HTS wires. It has already been shown that based on the experimen...

Effective condition monitoring of induction motors requires knowledge of the number of rotor slots and the rotor speed. These were primarily obtained in the literature by multiple measurements and using design knowledge of the motor under test. Furthermore, the earlier studies have mainly concentrated on stator current analysis. This paper investigates the use of the stator current, axial flux,...

This paper presents an effective rotor current controller for variable-speed stand-alone doubly fed induction generator (DFIG) systems feeding an unbalanced three-phase load. The proposed current controller is developed based on proportional plus two resonant regulators, which are tuned at the positive and negative slip frequencies and implemented in the rotor reference frame without decomposin...

this paper represents the performance of a squirrel-cage high temperature superconducting induction/ synchronous motor (hts-ism) based on nonlinear electrical equivalent circuit. the structure of the hts-ism is the same as that of the squirrel-cage type induction machine, and the secondary windings are fabricated by the use of the hts wires. it has already been shown that based on the experimen...

Single-phase squirrel cage and three-phase induction electromotors are the most popular electromotors used in industry from long ago. When an induction motor starts with direct connection method, it takes a lot of current from the power supply (several times the nominal current); so, several methods have been devised to start such electromotors. These methods either reduce the voltage of the st...

In a surface-mounted sintered NdFeB permanent-magnet generator, the magnets are usually thin (typically 4 mm), and hence the armature reaction, due to the time harmonics in the stator currents, is high. NdFeB magnets are conducting (resistivity typically 1.6 μΩm) and experience eddy-current losses. Therefore, the combined eddy-current losses in the NdFeB magnets and a solid iron rotor may becom...

The paper proposes a methodology for reliable design and maintenance of wind turbine rotor blades using a condition monitoring approach and a damage tolerance index coupling the material and structure. By improving the understanding of material properties that control damage propagation it will be possible to combine damage tolerant structural design, monitoring systems, inspection techniques a...

This paper presents newsensorless rotor position detection for a Three-phase single switch SR motor with regeneration capability at standstill mode. The proposed method is based on the dependency of phase current waveform at turn off time to rotor position angle. It is shown that the combination of a motor with single switch per phase converter and a transient voltage suppressor (TVS) circuit d...

Stable rotor levitation is a challenge for rotational gyroscopes (magnetically suspended gyroscopes (MSG) and electrostatically suspended gyroscopes (ESG)) with a ring- or disk-shaped rotor, which restricts further improvement of gyroscope performance. In addition, complicated pick-up circuits and feedback control electronics propose high requirement on fabrication technology. In the proposed g...

This paper describes the comparison of Artificial Intelligence (AI) based rotor position estimation techniques for Switched Reluctance Motor (SRM) with respect to its execution time in Digital Signal Processor (DSP) TMS320F2812. The various networks of Artificial Neural Network (ANN) and Adaptive Neuro Fuzzy Inference System ( ANFIS) structures are trained for mapping the nonlinear current-flux...