Objectives: This In-vitro study was designed to compare the Impact strength and Residual monomer content of conventional and high impact types of denture base resins polymerized by Compression and Injection molding technique with short curing cycle. Materials and Methods: Forty samples were made (twenty from each technique)in the dimension of 60 × 10 × 3 with 2 mm notch on the thickness side. T...

BACKGROUND Microwave postpolymerization has been suggested as a method to improve the flexural strength of an autopolymerizing denture reline resin. However, the effect of microwave postpolymerization on the residual monomer content and its influence on flexural strength have not been investigated. OBJECTIVES This study analyzed the effect of microwave postpolymerization on the residual monom...

Background: After polymerization process, heat cured acrylic resin denture base actually still contains residual monomers that can become potential irritants later in oral cavity. Polymerization process is essential to obtain acrylic resin which can meet the requirements of the biocompatible and good physical properties. To meet the requirements, there are several methods of polymerization proc...

Photopolymers are interesting materials for use in recording information in holography. We study the holographic behavior and stability of volume holograms recorded in poly(vinyl alcohol)--acrylamide photopolymers with and without a cross linker. Using a first-harmonic diffusion model, we analyze the residual monomer that remains when volume diffraction gratings are recorded in photopolymer mat...

The degree of polymerization of an acrylic resin repair material, as established by residual monomer estimation, was compared using three different polymerization methods, i.e. bench-cure, hydroflask-cure and microwave irradiation cure. The repair strength of a conventional heat-polymerized resin was then assessed following repairs using each of these three methods. The lowest level of residual...

Three heat-cured and three autopolymerized acrylic denture bases with different mixing proportions and/or processing methods were investigated for the amount of residual monomer content and methyl methacrylate (MMA) released into saliva after incubation during the first and second 24 hours after processing. A corresponding range of concentrations of MMA was also used to test for cell cytotoxici...

The samples were prepared according to the routine work for sample preparation in dental laboratories. After reaching dough stage, the mixture packed into dumbbell shaped of stainless steel mould and pressed in a hydraulic bench press for 25 min at room temperature. For heat-cure, the polymerization cycle was carried out using water bath, while self-cure done at room temperature. The residual m...