The ALMA Band 6 (211-275 GHz) receivers use sideband-separating SIS mixer-preamplifiers with dual 4-12 GHz IF outputs. The sideband-separating mixers are of the phasing type, with the LO driving two component mixers in-phase and the RF signal connected to the mixers through a quadrature hybrid. The IF outputs of the mixers are amplified, then combined in a quadrature hybrid which separates the ...

The preamplifier is a critical component of gyrometer’s electronics. Indeed the resolution of the sensor is limited by its signal to noise ratio, and the gyrometer’s thermal stability is limited by its gain drift. In this paper, five different kinds of preamplifiers are presented and compared. Finally, the design of an integrated preamplifier is shown in order to increase the gain stability whi...

This dissertation demonstrates the feasibility of three novel low-power and low-noise schemes for the readout interfaces of MEMS Capacitive Microphones (MCM) by presenting their detailed design descriptions and measurement results as application-specific ICs (ASIC) in CMOS technology developed to exploit their application scope in consumer electronics and hearing aids. MCMs are a new generation...

In the paper, the influence of temperature variation on the sensitivity of an avalanche-photodiode-based optical receiver applied in the free space optical communication link is discussed. Communication systems of this type are exposed to a wide range of operating temperatures, which markedly affect many photodiode and preamplifier parameters. The paper presents a receiver sensitivity calculati...

The preamplifier is a critical component of gyrometer’s electronics. Indeed the resolution of the sensor is limited by its signal to noise ratio, and the gyrometer’s thermal stability is limited by its gain drift. In this paper, five different kinds of preamplifiers are presented and compared. Finally, the design of an integrated preamplifier is shown in order to increase the gain stability whi...

A InGaAs PIN-photodetector and a lumped SHBT-transimpedance-preamplifier have been mono-lithically integrated and characterized. The preamlifier achieves a transimpedance gain of 44:6 dB (170) and the optical/electrical ?3dB-bandwidth of the entire receiver is 46 GH z. This is, to the best of our knowledge, the highest bandwidth for any HBT based photoreceiver reported to date.

We developed preamplifier configurations used to readout resistive bolometers such as those based on Neutron Transmuted Doped Germanium thermometers (so called NTD Ge thermometers)[1] or NbSi thin film thermometers [2, 3]. We introduce the impedance regulating preamplifier configuration. This configuration, is compared to previously proposed readout configurations with feedback on the bolometer...

Introduction In order to maximize the signal-to-noise-ratio (SNR) performance of an MR receiver coil the preamplifier used should add as little noise as possible. The amount of added noise is characterized by its noise figure (NF). Standard NF measurement of a preamplifier requires a tuner to present reference noise at varying complex impedance to the input of the device. Such tuners are not co...