Aluminum alloys with nanocrystalline (NC) and ultrafine grain (UFG) size are of interest because of their strengths that are typically 30 pct greater than conventionally processed alloys of the same composition. In this study, UFG AA 5083 plate was prepared by quasi-isostatic (QI) forging of cryomilled powder, and the microstructure and mechanical behavior was investigated and compared with the...

Al 5083 alloy powder was mechanically milled in liquid nitrogen to achieve a nanocrystalline (NC) structure having an average grain size of 50 nm with high thermal stability, and then consolidated by quasi-isostatic (QI) forging. The consolidation resulted in ultrafine grains (UFG) of about 250 nm, and the bulk material exhibited enhanced strength compared to conventionally processed Al 5083. T...

Al–Mg alloy powder was cryomilled to achieve a nanocrystalline (NC) structure having an average grain size of 50 nm with high thermal stability, and then consolidated by quasi-isostatic forging. The consolidation resulted in a bulk material with ultrafine grains of about 250 nm, and the material exhibited enhanced strength compared to conventionally processed Al–Mg alloy. The hardness of as-cry...

Beta-titanium alloys containing only fully biocompatible elements are very perspective materials for production of bioimplants. They have good properties for use as biomaterials, including above mentioned biochemical compatibility, low elastic modulus (important for biomechanical compatibility), in comparisson with previously used alloys. Moreover they are suitable for forging. Perspective meth...

The high cost of titanium alloys can be reduced using alternative manufacturing techniques and cheap alloying elements. In this study, the Ti-5Al-2.5Fe alloy, a cheaper α + β alloy than workhorse Ti-6Al-4V, was produced by powder metallurgy combined with hot thermomechanical deformation means forging. forged subsequently subjected to heat treatment at 750 °C for several annealing times in order...

An axisymmetric hot closed die-forging process has been studied by physical modeling technique using the plasticine. To observe the material flow pattern, layers of plasticine with different colors were used. The normal direction to the layers was considered a principal direction. The strain distribution was obtained by measuring the thickness of the plasticine layers. Based on the strain distr...

A new P/M route based hot powder pre-form forging process has been evolved to develop high density brake materials for heavy duty applications. Number of iron based MMC’s so developed offer better characteristics for braking applications in comparison to the materials developed through conventional P/M route based on high pressure compaction and pressure sintering. The process so developed in t...

The exponential increase of industrial demand in the past two decades has led scientists to the development of alternative technologies for the fast manufacturing of engineering components, aside from standard and time consuming techniques such as casting or forging. Cold Spray (CS) is a newly developed manufacturing technique, based upon the deposition of metal powder on a substrate due to hig...

The influence of SnO2 nanoparticles and method of their introduction in silver matrix on microstructure and physical properties such as density, porosity, hardness and electrical conductivity of Ag-SnO2 electrical contact materials were studied. The SnO2 nanoparticles were introduced by conventional powder mixing and by template method using different templates. All investigated samples were pr...