in the construction process of a plastic concrete cut-off wall, concreting is usually performed using the termie pipe method. in this method, concreting is performed from the lowest point in the excavated trench (containing the slurry) using a funnel and the pipe connected to it. the concrete poured in the funnel gradually settles in the panel through the termie pipe which is beneath the slurry...

Landfill sites are becoming over crowded and expensive for waste disposal, efforts are made to minimize the quantities of materials that are delivered to landfills. The threat due to leaching of non-biodegradable materials like waste plastics, scrap tyres. e-waste may contaminate the soil and ground water. If the production of waste cannot be prevented, then it is attractive to create an altern...

Concrete rheological properties need to be properly measured and predicted in order to characterize the workability of fresh concrete, including special concretes such as self-consolidating concrete (SCC). It was shown by a round-robin test held in 2000 [1,2] that different rheometer designs gave different values of viscosity for the same concrete. While empirical correlation between different ...

Five methods are introduced for design of castellated I beams encased in concrete. One of the methods, plastic analysis, is thoroughly explained and the relevant equations are developed. Eight castellated I beams encased in concrete are made and tested. The theoretical design methods are all compared with the test results and the safety factor for each method is calculated. The results show tha...

In the construction process of a plastic concrete cut-off wall, concreting is usually performed using the termie pipe method. In this method, concreting is performed from the lowest point in the excavated trench (containing the slurry) using a funnel and the pipe connected to it. The concrete poured in the funnel gradually settles in the panel through the termie pipe which is beneath the slurry...

plastic shrinkage is one of the most important parameter which must be considered in hot weather concreting. if plastic shrinkage is not prevented, cracking will be significant, especialy if silica fume is used in the mix. in this paper, the effect of silica fume in bleeding and evaporation was investigated in laboratory. the results showed that in restrained shrinkage, beside relative humidity...

To assess the performance criteria of the reinforced-concrete, five-storey residential buildings common in Iran, an &#10experimental study in the structural laboratory of the University of Tehran has been conducted. The test program includes cyclic and monotonic load tests of six beams that represent three-to-five storey buildings with rigid frame structures. Using definitions given in FEMA-356...

A plasticity-fracture constitutive model is presented for prediction of the behavior of confined plain concrete. A three-parameter yield surface is used to define the elastic limit. Volumetric plastic strain is defined as hardening parameter, which together with a nonlinear plastic potential forms a non-associated flow rule. The use of non-associated flow rule improves the prediction of the dil...

Industrial activities in Iraq are associated with significant amounts of non-biodegradable solid waste, waste plastic being among the most prominent. This study involved 86 experiments and 254 tests to determine the efficiency of reusing waste plastic in the production of concrete. Thirty kilograms of waste plastic of fabriform shapes was used as a partial replacement for sand by 0%, 10%, 15%, ...