The dual fuel engines at part loads inevitably suffer from lower thermal efficiency and higher carbon monoxide and unburned fuel emission. This work is carried out to investigate combustion characteristics of a dual fuel (dieselgas) engine at part loads, using a single zone combustion model with detailed chemical kinetics for combustion of natural gas fuel. The authors developed software in ...

air pollution is one of the major issues about the diesel engines in todays' world. it is a special concern in those areas that have difficulty meeting health-based outdoor air quality standards. natural gas has low emission and resource abundance and also conventional compression ignition engine can be easily converted to a dual fuel mode to use natural gas as main fuel and diesel as pilo...

The paper investigates the result on the existing diesel engine that can suitably modified to operate on the diesel fuel mode to conserve diesel and also reduce environmental pollution. The conventional fuels, petrol’s and diesel for internal combustion engines are exhausted at an alarming rate, due to increase of vehicle population and also these fuel causes environmental problems. Make these ...

In this study, corn oil as vegetable oil, chicken fat and fleshing oil as animal fats were used to produce methyl ester in a biodiesel pilot plant. The FFA level of the corn oil was below 1% while those of animal fats were too high to produce biodiesel via base catalyst. Therefore, it was needed to perform pretreatment reaction for the animal fats. For this aim, sulfuric acid was used as cataly...

In a previous study, multiple regression techniques were applied to Flight Operations Quality Assurance-derived data to develop parsimonious model(s) for fuel consumption on the Boeing 757 airplane. The present study examined several data mining algorithms, including neural networks, on the fuel consumption problem and compared them to the multiple regression results obtained earlier. Using reg...

The present experiment examined pilot response to the rapid cycling of automation. The experiment was conducted using a multi-task simulation environment consisting of tracking, fuel management, and system monitoring sub-tasks. Monitoring and fuel management sub-tasks were performed manually in all conditions. The tracking sub-task cycled between manual and automated control at fixed intervals ...

Fuel feeding and inhomogeneity of fuel typically cause process fluctuations in the circulating fluidized bed (CFB) process. If control systems fail to compensate for the fluctuations, the whole plant will suffer from fluctuations that are reinforced by the closed-loop controls. This phenomenon causes a reduction of efficiency and lifetime of process components. Therefore, domain experts are int...

Metals contained in the waste transfer to the waste incineration products, including flue gas, fly ash, and bottom ash, as different oxide, nitride, carbides, and other phases. Most of the metal-based phases formed in incineration are toxic and their emissions need to be strictly controlled. Therefore, behavior of metal species during incineration must be well understood. Such understanding is ...