A new approach to magnet fabrication, react, wind and sinter (RWS), has been proposed for Bi Sr CaCu O (Bi2212), magnets. In this process, the conventional Bi2212 heat treatment is split into two portions, and the magnet is wound between these heat treatments. Here we report results on the RWS “split melt process”. Significant increases in are obtained in Bi2212 round wires compared to standard...

The objective of present study was to evaluate the effect of processing methods and sintering condition on matrix formation and subsequent drug release from wax matrix tablets for controlled release. Ketorolac tromethamine and compritol were processed with appropriate diluent using either dry blending, spray drying, partial melt granulation or melt granulation.The tablets were then sintered at ...

Polymers for hot melt extrusion must exhibit thermoplastic characteristics in order to permit the melt extrusion process and they must be stable at extrusion temperatures. Other relevant characteristics are: suitable glass transition temperature (Tg) of 50–180 °C, low hygroscopicity and no toxicity since larger amounts of polymer are used [1]. Extrudability of a polymer is mainly determined by ...

Thermally processed hydroxyapatite coatings used on dental implants and hip prostheses for enhanced fixation may typically consist of a number of chemical and structural phases. These phases affect coating performance and tissue attachment. Hydroxyapatite was plasma sprayed to examine the phase evolution during processing. Coatings were examined with X-ray diffraction and elemental analysis. Re...

The thermal stability of polyethylene oxide (PEO) in sustained release tablets prepared by hot-melt extrusion was investigated. The weight average molecular weight of the polymer was studied using gel permeation chromatography. The chemical stability of PEO was found to be dependent on both the storage and processing temperature, and the molecular weight of the polymer. Storage of the polymer a...

Abstract: structures in alloys. This method is based on pouring the melt through a small sized nozzle into a mould located at acertain height under the crucible. This simple method generates globular structures without using equipments such asimpellers, electromagnetic stirrers, ultrasonic probes and cooling slopes. Therefore it is cost effective. In the presentstudy, the effect of casting size...

Despite some pitfalls in the practical application of the gas assisted injection moulding (GAIM) process, it offers a number of advantages over conventional injection moulding. However, its inherent complexity requires an advanced control over several additional parameters. This study is preliminar to examine the gas void and its relation to channel geometry and processing conditions for differ...