BACKGROUND To evaluate a potential correlation between flexural strength and indirect tensile strength in assessing the mechanical strength of resin composite cements. METHODS Flexural strength (n = 5) and indirect tensile strength (n = 5) of 7 resin composite cements (RelyX Unicem 2 Automix [RXU], Panavia SA [PSA], Clearfil SA [CSA], Panavia F2.0 [PF2], Multilink Implant [MLI], DuoCem [DCM],...

Using nano-technology materials in the asphalt pavement industry is new compared with Portland cement concrete. The main objective of this study is to investigate the effects of nano-silica modification on some properties of a penetration grade asphalt cement and a typical asphalt concrete. 60/70 penetration grade bitumen was modified with different percentages of nano-silica (i.e. 1, 3 and 5%,...

The fatigue cracks are observed in asphalt surfaces much more than ruts. This paper deals with the influence of carbon nano-tube on the fatigue life of asphalt mixtures. These samples are made up of the slabs cut by the asphalt cutting saw. Fatigue beams contain 0, 0.3, 0.6, 0.9, 1.2, and 1.5 percent of Carbon Nano-tube. The fatigue experiment was conducted using a 4-point semi-sinusoidal loadi...

This work presents the effects of strain rate on the tensile properties and fracture morphologies of AHSS-DP 350/600 subjected to LSP. Fatigue crack growth test was performed to evaluate fatigue behavior in the metallic plate of AHSS-DP350/600. However, this material is used in automobile industry and enhancing it fatigue resistance is a challenge in material engineering. In order to evaluate a...

This paper describes a nano-scale tensile test to study the fatigue properties of LPCVD silicon nitride thin films using a novel electrostatic actuator design. Mechanical-amplifier devices made in silicon nitride thin films can apply controllable tensile stress (2.0–7.8 GPa) to test structures with relatively low actuation voltages (5.7–35.4 VRMS) at the resonant frequencies of the devices. The...

cracked and un-cracked brazilian disc specimens subjected to diametral compression were used for conducting fracture toughness and tensile strength experiments on a polymer concrete (pc) material. the value of mode i fracture toughness (kic) was determined from the center- cracked brazilian disc and the indirect tensile strength (σt) was obtained from the un-cracked brazilian disc specimen. the...

BACKGROUND Bioprostheses for cardiovascular surgery have limitations in their use following as calicification. α-galactosidase epitope is known as a stimulant of immune response and then shows a progressing calcification. The objective of this study was to evaluate histologic characteristics and mechanical properties of decellularization and treated with α-galactosidase. MATERIALS AND METHODS...

Microalloyed S355N steel plates are extensively used in bridge and high-rise building structures. One of the factors affecting the mechanical properties is the size and morphology of inclusions. In this research, microalloyed S355N steel plates with different sizes of inclusions were examined. One contained long manganese sulfide inclusions (LI material) and the other had short ones (SI materia...

BACKGROUND Aim of the study was to verify the efficiency of Martens hardness measurements in detecting the degradation of composite resin cements during artificial aging. METHODS Four cements were used: Variolink II (VL2), RelyX Unicem 2 Automix (RUN), PermaFlo DC (PDC), and DuoCem (DCM). Specimens for Martens hardness measurements were light-cured and stored in water at 37 °C for 1 day to al...